Table of Contents
Advertisement
Description
NOTICE
It is the equipment owners responsibility to provide any
scaffolding or other apparatus required to perform
emergency service or annual/periodic maintenance to
this equipment.
The Separated Combustion Gas-Fired Blower Unit Heaters
are factory assembled, high static pressure type,
centrifugal blower units designed for heavy duty
applications such as continuous operation or where a
Figure 1.
Tubular blower unit heater
See Identification of Parts,
The following terms are used throughout this manual, in
addition to the ETL requirements to bring attention to the
presence of potential hazards, or to important information
concerning the product:
WARNING
Indicates an imminently hazardous situation which, if
not avoided, could result in death, serious injury, or
substantial property damage.
CAUTION
Some Indicates an imminently hazardous situation
which, if not avoided, may result in minor injury, or
property damage.
NOTICE
Used to notify of special instructions on installation,
operation, or maintenance which are important to
equipment but not related to personal injury.
For your saftey:
The use and storage of gasoline or
other flammable vapors and liquids in open containers in
the vicinity of this appliance is hazardous.
For your saftey:
If you smell gas:
1. Open windows.
2. Don't touch electrical switches.
3. Extinguish any open flame.
GKNE-SVX001B-EN
Figure 18
through
Figure
single unit heater must do the entire heating job in a large
area.These blower type unit heaters may be used with the
standard adjustable louvers, with short duct runs or
discharge nozzles for spot heating. These blower type unit
heaters may be used where low sound levels are required.
The designs are certified by ETL as providing a minimum
of 83% thermal efficiency, and approved for use in
California. Do not alter these units in any way. If you have
any questions after reading this manual, contact the
manufacturer.
26.
4. Immediately contact your gas supplier.
Improper installation, adjustment, alteration, service or
maintenance can cause property damage, injury, or
death. Read the installation, operating, and
maintenance instructions thoroughly before installing
or servicing this equipment.
Installer's responsibility:
equipment has been test fired and inspected. It has been
shipped free from defects from our factory. However,
shipment and installation problems such as loose wires,
leaks, and loose fasteners may occur. It is the installer's
responsibility to inspect and correct any problem that may
be found.
Receiving instructions:
when received to determine if any damage has occurred to
the unit during shipment. After the unit has been uncrated,
check for any visible damage to the unit. If any damage is
found, the consignee should sign the bill of lading
indicating such damage and immediately file claim for
damage with the transportation company.
Install, operate, and maintain unit in accordance with
the manufacturer's instructions to avoid exposure to
fuel substances, or substances from incomplete
combustion, which can cause death or serious illness.
The state of California has determined that these
substances may cause cancer, birth defects, or other
reproductive harm.
WARNING
Installer Please Note: This
Inspect shipment immediately
WARNING
5
Advertisement
Table of Contents
