Mower Assembly; Install Deflector (50" Models); Install Idler Spring (50" Models); Install Crank (Free Floating Mowers) - Simplicity Regent Series Dealer Setup & Adjustment Instructions Manual

Mower Assembly

Install Deflector (50" Models)

WARNING
For your personal safety, do not handle the sharp
mower blades with bare hands. Careless or
improper handling of blades may result in serious
injury.
1. Remove and retain the hardware securing the
deflector (I, Figure 3) to to the mower deck.
2. Secure the rod (C) to the mower deck as shown using
one 1/4-20 x 7/8 carriage bolt (H), one 1/4 push nut
(D), one 1/4 flat washer (B), and one 1/4-20 locknut
(A).
3. Install the spring (E) in the center notch of the
deflector (I).
4. Install the deflector (I), spring (E), 5/16 washer (F),
and clamp (G) on rod (C).
5. Wind the spring (E) 1/2 turn so that the legs will force
the deflector down in to the operating position.
Secure using one 1/4-20 x 7/8 carriage bolt (H), one
1/4 push nut (D), one 1/4 flat washer (B), and one
1/4-20 locknut (A).
1/2006
Regent / 500 / 2500 / LT Series
I
A
G
F
B
D
H
Figure 3. Deflector Installation (50" Models)
A. Locknuts, 1/4-20
B. Washers, Flat, 1/4
C. Rod
D. Push Nuts, 1/4
E. Spring
F. Washer, Flat, 5/16
G. Clamp
H. Carriage Bolts, 1/4-20 x 7/8
I. Deflector
5
A
B
C
D
E
TP 300-4218-04-RG-SMAN