CyberPower PowerPanel Power Supply System User Manual page 19

overloaded
Battery-test failure
Batteries are not
present
Batteries need to be
replaced
Communication lost
Communication
cannot establish
Remaining runtime
is insufficient
Shutdown initiated
A schedule has
initiated
Enters bypass mode
The battery-test failed to provide battery power normally.
Batteries are not present; the Battery Backup cannot
provide battery power in this condition.
Batteries may not work well any more; they need to be
replaced with new ones.
Communication with device has been lost.
Communication cannot establish during startup.
Information
This event will occur when the battery is fully charged
and the remaining runtime is still less than sum of times
set in the following categories:
Event Utility power failure and Low Battery
•
shutdown action delay time.
Event Shutdown is initiated command file
•
execution time.
OS shutdown time.
•
All connected Slave OS shutdown time.
•
Plus an additional 30 seconds.
•
You need to unload some equipment connected to
the Battery Backup to get more remaining runtime.
Please make sure all connected equipment will have
enough remaining runtime when power problem
occurs.
Shutdown process initiated.
A schedule has initiated, the system could be shutdown.
This event occurs when any one of following things
happens:
The schedule setup controlled outlet to Whole
•
outlet.
The Battery Backup support standalone outlet
•
control and the schedule setup controlled outlet to
Outlet#1 or Outlet2 and enable Shutdown OS.
Enters bypass mode for power supply, battery power will
no longer be provided.
Copyright © 2006-2007 Cyber Power Systems, Inc. All rights reserved.
®
PowerPanel Business Edition
18