Table of Contents
Advertisement
7 Installation
Prior to installation, the following documents should be to hand:
• Data sheet of the product (contains the permissible technical data,
main dimensions and circuit diagrams of standard versions)
7�1 Unpacking
NOTICE! Danger due to electrostatic discharge!
When unpacking the analog amplifier, there is a danger of damage to the electronic
components of the analog amplifier due to electrostatic discharge.
▶ When unpacking, protect the analog amplifier against electrostatic discharge;
information on the protection of the analog amplifier against electrostatic
discharge (ESD) can be found in the respective data sheet
(Table 1 "Required and supplementary documentation" on page 5).
▶ Remove the packaging from the analog amplifier.
▶ Check the analog amplifier for transport damage and completeness,
see chapter 4 "Scope of delivery" on page 13.
▶ Dispose of the packaging in accordance with the regulations in your country.
7�2 Installation conditions
▶ Do not install the control unit near parts which generate considerable heat
(e.g. exhaust).
▶ Radio equipment and mobile telephones must not be used in the driver's cab
without a suitable antenna or near the control electronics.
▶ A sufficiently large distance to radio transmission systems must be maintained.
▶ All connectors must be unplugged from the electronics during electrical
welding or painting operations.
▶ The control units must not be electrostatically charged, e.g. during painting
operations.
▶ The control unit will heat up beyond normal ambient temperature during
operation. To avoid danger caused by high temperatures, it should be protected
against contact.
▶ Standing and permanently running water is not permissible in the area
of the seal.
Installation | Analog amplifier RA
RE 95230-B/2021-12-01, Bosch Rexroth AG
19/48
Hide quick links:
Advertisement
Table of Contents
