The following lead free (PbF) solder wire gauges are recommended for service of this product:
0.3mm, 0.6mm and 1.0mm.
1.2. HOW TO RECOGNIZE THAT Pb FREE SOLDER IS USED
PbF is stamped to show that Pb free solder is used. (See the figure below.)
2. FOR SERVICE TECHNICIANS
ICs and LSIs are vulnerable to static electricity.
When repairing, the following precautions will help prevent recurring malfunctions.
1. Cover the plastic parts boxes with aluminum foil.
2. Ground the soldering irons.
3. Use a conductive mat on the worktable.
4. Do not touch IC or LSI pins with bare fingers.
3. SPECIFICATIONS
Station Loop
90 ohms
Limit:
Calling Method:
2 pair wire
Jacks:
Handset Jack, TEL Jack
Dimensions:
Low
Angle:
High
Angle:
Weight:
0.7 kg
Design and specifications are subject to change without notice.
4. LOCATION OF CONTROLS
213 (D)mm × 177 (W)mm × 107 (H)mm
201 (D)mm × 177 (W)mm × 127 (H)mm
3