Table of Contents
Advertisement
Page notification
The remote control can be programmed to notify the user of a
page (audibly beeping if the vehicle's status changes, e.g. door
unlocked, engine started, vehicle violation, etc.). Press
select page On/Off. One beep is page On, Two beeps is page Off.
When programmed off the remote will not give any notification
that a page was received from the vehicle.
To exit programming mode
The remote control will exit programming mode after 2-seconds
of inactivity and will emit 2 long beeps.
u u s s i i n n g g y y o o u u r r s s y y s s t t e e m m
➜
warning! safety first
The following safety warnings must be observed at all times:
➤
Due to the complexity of this system, installation of this
product must only be performed by an authorized Directed
dealer.
➤
When properly installed, this system can start the vehicle via
a command signal from the 2-way remote control. Therefore,
never operate the system in an enclosed area or partially
enclosed area without ventilation (such as a garage). When
parking in an enclosed or partially enclosed area or when
having the vehicle serviced, the remote start system must be
disabled using the installed toggle switch. It is the user's sole
responsibility to properly handle and keep out of reach from
children all 2-way remotes to assure that the system does not
unintentionally remote start the vehicle. T T H H E E U U S S E E R R M M U U S S T T
© 2005 directed electronics—all rights reser ved
to
13
Advertisement
Table of Contents
