Base Unit Dimensions - Carrier 48TJD Installation, Start-Up And Service Instructions Manual

STANDARD DURABLADE
UNIT ECONOMIZER
UNIT
WEIGHT WEIGHT
48TJ
Lb Kg Lb Kg
E/F004 460 209 34 15.4
D/E/F005 470 213 34 15.4
D/E/F006 490 222 34 15.4
D/E/F007 565 256 34 15.4
CONNECTION SIZES
" " " " Dia [27] Field Power Supply Hole
1
A 1 /
16
" " " " -14 NPT Condensate Drain
3 /
B
4
" " " " -14 NPT Gas Connection
1 /
C
2
NOTES:
1. Dimensions in [ ] are in millimeters.
2. Center of gravity.
3. Direction of airflow.
4. On vertical discharge units, ductwork to be attached to accessory roof curb only. For horizontal dis-
charge units, field-supplied flanges should be attached to horizontal discharge openings, and all
ductwork should be attached to the flanges.
5. Minimum clearance (local codes or jurisdiction may prevail):
a. Between unit, flue side and combustible surfaces, 36 inches.
b. Bottom of unit to combustible surfaces (when not using curb), 1 inch.
Bottom of base rail to combustible surfaces (when not using curb) 0 inches.
c. Condenser coil, for proper airflow, 36 in. one side, 12 in. the other. The side getting the greater
clearance is optional.
d. Overhead, 60 in. to assure proper condenser fan operation.
e. Between units, control box side, 42 in. per NEC.
f. Between unit and ungrounded surfaces, control box side, 36 in. per NEC.
g. Between unit and block or concrete walls and other grounded surfaces, control box side, 42 in.
per NEC.
h. Horizontal supply and return end, 0 inches.
6. With the exception of the clearance for the condenser coil and combustion side as stated in notes
5a, b and c, a removable fence or barricade requires no clearance.
7. Units may be installed on combustible floors made from wood or Class A, B, or C roof covering
material if set on base rail.
8. The vertical center of gravity is 1'-6" [457] up from the bottom of the base rail.
CORNER CORNER
ECONOMI$ER
WEIGHT WEIGHT
WEIGHT
(A) (B)
Lb Kg Lb Kg Lb Kg
47 21.3 140 63.5 105 47.6
47 21.3 142 64.4 106 48.1
47 21.3 150 68.0 115 52.2
47 21.3 165 74.8 136 61.7
Fig. 6 — Base Unit Dimensions
BOTTOM POWER CHART, THESE HOLES REQUIRED FOR
CORNER CORNER
USE WITH ACCESSORY PACKAGES — CRBTMPWR001A00,
WEIGHT WEIGHT
(C) (D)
Lb Kg Lb Kg
159 72.1 56 25.4
CONDUIT SIZE
162 73.5 60 27.2
160 72.6 65 29.5
200 90.7 64 29.0
8
(POWER AND CONTROL) AND CRBTMPWR003A00
(POWER, CONTROL, AND GAS)
THREADED WIRE REQURED
USE HOLE SIZES (MAX.)
" " " " " " " " [22.2]
1 / 24 V 7 /
2 8
" " " " " " " " [28.4]
3 / Power 1 1 /
4 8
" " " " FPT " " " " [31.8]
1 1
/ Gas 1 /
2 4