Toro 21761 Operator's Manual page 18

Figure 19
2. Ensure that the cutting-height setting on the
machine is 92 mm (3-5/8 inches) or lower. If
it is not, lower it; refer to
Height (page 9).
3. Disengage the handle locks
Figure 20
1. Handle lock disengaged
positions
4. Fold the handle fully forward
Important:
Route the cables to the outside
of the handle knobs as you fold the handle.
5. Engage the handle locks.
6. Lift the front of the machine by the handle and
move it into a storage space
decal133-8198
Adjusting the Cutting
(Figure 20).
g189218
2. Handle lock engaged
position
(Figure 20).
(Figure 21).
16
Figure 21
g189217