Operating Instructions; Operation; Stand-Alone Mode (Sound-Active, Auto Mode); Master/Slave Mode (Master Sound, Master Auto) - Chauvet Vue III User Manual

4. O
PERATING

Operation

Stand-Alone Mode (Sound-Active, Auto Mode, Strobe Mode, All On):
This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto
Mode.
1) Set dipswitches position to desired mode.
Mode
Sound-Active
Auto Mode
Strobe Mode
All On
*Effect speed
1 on = slow
1-2 on = medium
1-3 on = fast
1-4 on = very fast
2) The unit will react to the low frequencies of music via the internal microphone in Sound-Active
mode, or the unit will auto change in Auto Mode.
3) Use the audio sensitivity knob on the back of the unit to make the unit more or less sensitive in
Sound-Active mode. Turning the knob counterclockwise decreases the sensitivity; turning the
knob clockwise increases the sensitivity.

Master/Slave Mode (Master Sound, Master Auto):

1) Use standard DMX cables to daisy chain your units together via the DMX connector on the rear
of the units. For longer cable runs we suggest a terminator at the last fixture. For more
information about terminators, see page 8.
2) Determine which fixture will be the master. Connect a DMX cable from the DMX output
connector of the master to the DMX input connector of another Vue™ III .
3) Continue connecting the slaves together with DMX cables.
4) Set the dipswitches on the master according to the desired mode of operation.
Mode
Master Sound
Master Auto
5) For auto mode, set dipswitches to the desired mode.
Mode
Auto Mode
Strobe Mode
All On
*Effect speed
1 on = slow
1-2 on = medium
1-3 on = fast
1-4 on = very fast

DMX Mode

This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with
DMX, please read the DMX Primer on page 16.
1) Set dipswitches 1-9 to the desired DMX address. For help setting the address, see the
"SETTING THE STARTING ADDRESS" section on page 13.
Vue™ III User Manual
I
NSTRUCTIONS
Dipswitches
1-10: Off
1-4: Effect speed*, 5-8: Off, 9: On, 10: Off
1-4: Off, 5-7: Strobe speed**, 8: Off, 9: On, 10: Off
1-7: Off, 8: On, 9: On, 10: Off
**Strobe speed
5-7 off = no strobing
5 on = slow strobing
5-6 on = medium strobing
5-7 on = fast strobing
Dipswitches
1-9 = Off, 10 = On
9 = On, 10 = On
Dipswitches
1-4: Effect speed*, 5-9: Off, 10: On
1-4: Off, 5-7: Strobe speed**, 8: Off, 9-10: On
1-7: Off, 8-10: On
**Strobe speed
5-7 off = no strobing
5 on = slow strobing
5-6 on = medium strobing
5-7 on = fast strobing
10
2007-05-10/15:08