Stihl FS 361 C-M Instruction Manual page 12

English
► Fit the nut (7).
► Insert and tighten down the screw (6) firmly.
It is not necessary to remove the bike handle
again.
6.2 Removing the Deflector and
the Limit Stop
6.2.1 Installing the Deflector and the Limit
Stop
► Shut off the engine.
1
► Position the guard (1) on the gear housing.
► Insert the screws (2) and tighten them to a tor‐
que of 10 Nm.
6.2.2 Removing the Deflector and Limit Stop
► Shut off the engine.
► Take out screws.
► Remove deflector.
6.3 Mounting and Removing the
Mowing Head
6.3.1 Mounting the Mowing Head
► Shut off the engine.
1
2
3
4
► Place the thrust plate (2) on the shaft (3) so
that its smaller diameter faces up.
► Fit the mowing head (1) on the shaft (3) and
turn it counterclockwise by hand.
► Insert the stop pin (4) in the bore up to the limit
stop and hold it depressed.
► Turn the mowing head (1) counterclockwise
until the stop pin (4) engages in position.
The shaft (3) is now blocked.
► Tighten down the mowing head (1) firmly by
hand.
12
2
1
4
► Remove the stop pin (4).
6.3.2 Removing the Mowing Head
► Shut off the engine.
► Insert the stop pin in the bore as far as stop
and hold it depressed.
► Rotate the mowing head until the stop pin
engages in position.
The shaft is now blocked.
► Unscrew the mowing head clockwise.
► Remove the thrust plate.
► Remove stop pin.
6.4 Removing and Installing Metal
Cutting Attachment
6.4.1 Mounting grass cutting blade, brush
knife or circular saw blade
► Shut off the engine.
1
2
3
4
5
6
7
► Place the thrust plate (5) on the shaft (6) so
that its smaller diameter faces up.
► Place the metal cutting attachment (4) on the
thrust plate (5). If you are fitting a circular saw
blade or a grass cutting blade with more than
4 cutting edges: Its cutting edges must face in
the same direction as the arrow on the deflec‐
tor.
► Place the thrust washer (3) on the metal cut‐
ting attachment (4) so that its raised side faces
up.
► Place the rider plate (2) on the thrust washer
(3) so that its closed side faces up.
► Insert the stop pin (7) in the bore up to the limit
stop and hold it depressed.
► Rotate the metal cutting attachment (4) coun‐
terclockwise until the stop pin (7) engages in
position.
The shaft (6) is now blocked.
6 Assembling the Trimmer
0458-838-0101-A