Download Print this page

JVC KD-DV5306 Installation & Connection Manual

Hide thumbs Also See for KD-DV5306:

Advertisement

Quick Links

KD-DV5306/KD-DV5305/
KD-DV4306/KD-DV4305
Installation/Connection Manual
Manual Pemasangan/Penyambungan
GET0439-008A
[UN]
ENGLISH
This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does
not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers.
WARNINGS
• DO NOT install any unit in locations where;
– it may obstruct the steering wheel and gearshift lever operations.
– it may obstruct the operation of safety devices such as air bags.
– it may obstruct visibility.
• DO NOT operate the unit while driving.
• If you need to operate the unit while driving, be sure to look ahead carefully.
• The driver must not watch the monitor while driving.
If the parking brake is not engaged, "DRIVER MUST NOT WATCH THE MONITOR WHILE
DRIVING." appears on the monitor, and no playback picture will be shown.
– This warning appears only when the parking brake wire is connected to the parking brake
system built in the car.
To prevent short circuits, we recommend that you disconnect the battery's negative terminal and make all
electrical connections before installing the unit.
• Be sure to ground this unit to the car's chassis again after installation.
Notes:
• Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio
dealer.
• It is recommended to connect to the speakers with maximum power of more than 50 W (both at
the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less than
50 W, change "AMP GAIN" setting to prevent the speakers from being damaged (see page 24 of the
INSTRUCTIONS).
• To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape.
• The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.
PRECAUTIONS on power supply and speaker connections:
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit
will be seriously damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in
your car.
Parts list for installation and connection
If any item is missing, consult your JVC car audio dealer immediately.
A / B
Hard case/Control panel
Kotak keras/Panel kontrol
F
Crimp connector
Konektor kerut
J
Rubber cushion
Bantalan karet
Heat sink
Pendingin
C
Sleeve
Selongsong
G
Washer (ø5)
Perapat sambungan (ø5)
K
Handles
Pegangan-pegangan
INDONESIA
Alat penerima ini didisain untuk beroperasi hanya pada 12 V DC, sistem listrik tanah NEGATIVE. Jika
kendaraan anda tidak memiliki sistem ini, sebuah pembalik tegangan diperlukan, yang mana dapat dibeli
di penyalur-penyalur audio mobil JVC.
PERINGATAN
• JANGAN memasang unit pada tempat-tempat dimana;
– ini dapat menghalangi pengoperasian roda kemudi dan tuas gigi persneling
– ini dapat menghalangi pengoperasian alat pengaman seperti kantung udara.
– ini dapat menghalangi pandangan.
• JANGAN mengoperasikan unit sewaktu mengemudi.
• Jika Anda harus mengoperasikan unit sewaktu mengemudi, pastikan Anda melihat ke depan
dengan hati-hati.
• Pengemudi tidak boleh menonton monitor selagi mengemudi.
Jika rem parkir tidak bekerja, "DRIVER MUST NOT WATCH THE MONITOR WHILE DRIVING."
muncul pada monitor dan tidak ada gambar putar ulang yang akan dipertunjukkan.
– Peringatan ini muncul hanya jika kabel rem parkir telah tersambung ke sistem rem parkir
yang terpasang tetap di dalam mobil.
Untuk mencegah hubungan pendek, kami menyarankan anda memutuskan sambungan terminal negatif
baterai dan membuat semua sambungan-sambungan listrik sebelum memasang alat penerima.
• Pastikan untuk mentanahkan alat penerima ini ke casis mobil kembali setelah pemasangan.
Catatan:
• Ganti sekring dengan voltase yang sudah ditetapkan. Jika sekring sering meledak, konsultasikan pada
penyalur audio mobil JVC anda.
• Disarankan untuk menghubungkan speaker-speaker dengan maksimum power lebih dari 50 W (keduanya
di belakang dan di depan, dengan sebuah impedansi 4 Ω sampai 8 Ω). Jika maksimum power kurang
dari 50 W, ganti pengaturan "AMP GAIN" ("PENAMBAH PENGUAT") untuk mencegah speaker-speaker
dari kerusakan (lihat halaman 24 dari BUKU PETUNJUK).
• Untuk mencegah hubungan pendek, tutup ujung-ujung terminal-terminal yang TIDAK DIGUNAKAN
dengan pita isolasi.
• Pendingin menjadi sangat panas setelah digunakan. Hati-hati untuk tidak menyentuhnya ketika
memindahkan alat penerima ini.
TINDAKAN-TINDAKAN PENCEGAHAN pada suplai power dan
sambungan-sambungan speaker:
• JANGAN sambungkan ujung-ujung speaker dari kabel power ke baterai mobil; sebaliknya,
alat penerima tersebut akan secara serius rusak.
• SEBELUM menyambung ujung-ujung speaker dari kabel power ke speaker-speaker, cek perkabelan
speaker dalam mobil anda.
Daftar bagian-bagian untuk pemasangan dan penyambungan
Jika ada item yang hilang, segera hubungi dealer audio mobil JVC anda.
D
Trim plate
Plat rapi
H
Lock nut (M5)
Mur kunci (M5)
L
Remote controller
Remote kontrol
1
1206DTSMDTJEIN
EN, IN
© 2006 Victor Company of Japan, Limited
E
Power cord
Kabel power
I
×
Mounting bolt (M5
20 mm)
Baut bingkai (M5 × 20 mm)
M
Battery
Baterai

Advertisement

loading

Summary of Contents for JVC KD-DV5306

  • Page 1 • Pastikan untuk mentanahkan alat penerima ini ke casis mobil kembali setelah pemasangan. Notes: Catatan: • Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio • Ganti sekring dengan voltase yang sudah ditetapkan. Jika sekring sering meledak, konsultasikan pada dealer.
  • Page 2 The following illustration shows a typical installation. If you have any questions or require information Ilustrasi berikut menunjukkan sebuah tipe pemasangan. Jika anda mempunyai suatu pertanyaan atau regarding installation kits, consult your JVC car audio dealer or a company supplying kits. informasi yang diperlukan mengenai alat-alat pemasangan, konsultasikan pada penyalur audio mobil JVC •...
  • Page 3 Connect the antenna cord. Sambungkan kabel antena. Finally connect the wiring harness to the unit. Akhirnya sambungkan dudukan kabel ke alat penerima. LINE IN For KD-DV5306/KD-DV5305 (see diagram VIDEO OUT Untuk KD-DV5306/KD-DV5305 (lihat diagram (see diagram / lihat diagram Rear ground terminal...
  • Page 4 Connecting the external components / Menyambung komponen eksternal JVC CD changer, Apple iPod, or JVC D. player / JVC CD changer, Apple iPod atau JVC D. player • Set “CHANGER” for the external input setting (See page 24 of the INSTRUCTIONS.) / Aturlah “CHANGER” untuk pengaturan input eksternal (Lihat halaman 24 dari BUKU PETUNJUK.) You can connect these components as illustrated below.

This manual is also suitable for:

Kd-dv5305Kd-dv4306Kd-dv4305