Technical Specification; Analog Video - Quartz Q16 System Manual

Quartz Q16/Q32 System Manual

Technical Specification

Analog Video

VIDEO INPUTS
Nominal signal level
video signal
sync pulses
subcarrier
Max signal level
dc restored inputs
video signal
sync pulses
dc coupled inputs
video or subcarrier
Impedance
Return Loss to 5.5 MHz
dc on input (dc restored)
VIDEO OUTPUTS
Impedance
Return Loss to 5.5 MHz
dc on output (see note 1)
INSERTION GAIN
Insertion gain
Gain spread between inputs
Adjustment range
LINEAR DISTORTION
HF response 15KHz to 5.5MHz
5.5 to 10MHz
10MHz to 100MHz
above 100MHz
HF adjustment at subcarrier
LF response, tilt at 50 Hz
Y-C gain inequality
Y-C delay inequality
NON-LINEAR DISTORTION
Differential Gain(10-90% APL)
Differential Phase(10-90%APL)
Luminance non-linearity
C-Y intermodulation
Dynamic gain (Y, C, sync)
Transient gain (Y, C, sync)
PROPAGATION DELAY
Path length - Q16 and Q32
Timing spread at 4.43MHz
one output
all outputs
Note 1: In the dc coupled mode the dc on the output is specified with the input terminated in 75Ω. In the dc restored mode the
specification refers to the black level when the sync amplitude is 300mv.
18 May 2004
UNWANTED RESIDUAL EFFECTS
Crosstalk, to 5.5MHz worst case
1v p-p Noise to 5.5MHz
2v p-p video spikes at switching
1v p-p
SWITCHING REFERENCE
Signal level
+6dB
2.5v p-p
Impedance
+/-0.7v
dc on input
Switching occurs on lines
75Ω terminating
40dB field or frame rate
+/-3v
POWER
Voltage, universal
Power consumption (Q16, Q32)
75Ω
Connector (Q16)
35dB
Connector (Q32)
+/-50mV
Power Fail Alarm Output (Q32)
+/-0.1dB
+/-0.05dB
+/-0.5dB
CONTROL
Q-link to remote panels
+/-0.1dB
Computer port RS232/RS422
+/-0.2dB
+0.5, -1.0dB
smooth roll off MECHANICAL
+/-0.5dB Height
+/-0.5%
+/-0.5%
+/-5nsec Width
Depth
Weight
0.15%
o
0.15
0.2%
0.5%
0.5%
1% ENVIRONMENTAL
Operating and storage (ambient)
Specification maintained (ambient)
Humidity
13nsec typical
condensing
o
+/-1
o
+/-2
Issue 5.00
1v p-p
1-4v pulses
Power Supply good
Power Supply failed\absent
Q16
Q32
Q16
Q32
58dB
-70dBrms
+/-20mv
+/-3dB
looping
+/-1v
6/319 to 10/323
link selectable
90-264v, 50/60Hz
20watts
IEC with latch
IEC with latch x 2
screw terminals
closing relay contact
rated at 250mA, 50v
open relay contact
75Ω video cable
500M max. length
D9 socket
1U, 44mm, 1.75"
2U, 88mm, 3.5"
19" rack mount
500mm
6Kg
12Kg
o
0-40 C
o
10-30 C
10-90% non-
Page 37