Unit Installation - Trane FWDP Series Installation Operation & Maintenance

WARNING:
OPEN AND
!
LOCK UNIT DISCONNECT TO
PREVENT INJURY OR DEATH
FROM ELECTRIC SHOCK OR
CONTACT WITH MOVING
PARTS BEFORE ATTEMPTING
ANY INSTALLATION OR
MAINTENANCE.
The general location of the air handler
is normally selected by the architect,
contractor, and/or buyer. For proper
installation, the following items must
be considered.
1.Available power supply must agree
with electrical data on component
nameplate.
2.Air handlers shipped wired for 220 -
240 Volt applications.
3.If external accessories are installed
on the unit, additional clearances
must be provided.
4.All duct work should be properly
insulated to prevent condensation
and heat loss.
Note: It is recommended that the
outline drawings (page6) be studied
and dimensions properly noted and
checked against selected installation
site.
Important: If adding
accessories to the unit, additional
clearances must be considered for the
over all space needed.
Lifting Recommendation
Before preparing the unit for lifting, the
center of gravity should be determined
for lifting safety. Because of the
placement of internal componets, the
unit weight may be
distributed.

Unit Installation

WARNING:
!
LIFTING EQUIPMENT MUST
BE CAPABLE OF LIFTING THE
WEIGHT OF THE UNIT WITH
AN ADEQUATE SAFETY
FACTOR. THE USE OF UNDER
CAPACITY LIFTING DEVICES
MAY RESULT IN PERSONAL
INJURY OR DEATH AND
CAUSE DAMAGE TO THE
UNIT.
The unit can be moved using a forklift
of suitable capacity. For lifting the unit
into an elevated mounting pasition, run
lifting straps or slings under the unit
and attach securely to the lifting device.
Use spreader bars to protect the unit
casing from damage. Test lift the unit
to determine proper balance and
stability.
Caution: Use spreader bars to prevent
straps from damaging the unit. Install
the bars between lifting straps, both
underneath the unit and above the unit.
This will prevent the straps from
crushing the unit cabinet or damaging
the unit finish.
Installation Considerations
For proper installation and operation,
check each of the following before
mounting the units.
external
(a)Space
Clearances.
Allow adequate space for the unit and
free air service clearances. See Figure
in page 3 general unit dimensions.
For servicing and routine maintenance,
provide access to the unit through
removable panels in the ceiling..
unevenly
ON SITE
Requirement And
4
TRANE
Figure 1
(b) Location, Mounting And Positioning
Before installing any unit make sure
proper preparation has been made
at each unit location for piping and
electrical connections.
®