Table of Contents
Advertisement
Parameters
6.4 Explanation of the module/channel parameters
Parameter
Input delay
3
(Page 21)
Hardware interrupts positive
edge
(Page 21)
3
Hardware interrupts nega‐
tive edge
(Page 21)
3
Potential group (Page 22)
The wire break diagnostics can only be enabled when the "Check for wire break" parameter is enabled.
1
If you use simple encoder contacts, you need to connect a resistor in parallel to enable a wire break check to be performed
2
when the contacts are open. The resistor used depends on the nominal input voltage of the module.
When time stamping with an accuracy of 1 ms is enabled, the input delay on all channels is switched off and the pulse
3
stretching and hardware interrupt for positive/negative edge is disabled on all channels (not adjustable).
6.3
Parameter reassignment
Definition
Each configuration change resets the corresponding reaction. Changing the configuration of a
function does not affect other functions.
6.4
Explanation of the module/channel parameters
6.4.1
Channel activated
Definition
Specifies whether a channel is activated or deactivated.
20
Value range
•
None
•
0.05 ms
•
0.1 ms
•
0.4 ms
•
0.8 ms
•
1.6 ms
•
3.2 ms
•
12.8 ms
•
20 ms
•
Activated
•
Deactivated
•
Activated
•
Deactivated
•
Use potential group of the left
module
•
Allow new potential group
Default
Parameter re‐
assignment in
3.2 ms
Yes
Deactivated
Yes
Deactivated
Yes
Use potential group
No
of the left module
Equipment Manual, 10/2021, A5E39288633-AD
Efficiency range
RUN
Channel
Channel
Channel
Module
DI 8x24...125VDC HA
Advertisement
Table of Contents
