Table of Contents
Advertisement
Default Setting Changes
Changing Default Settings
To change a default parameter setting, go to the root of the Program menu and turn the Rotary
Encoder until the desired parameter group is within the cursor block. Press the Rotary Encoder (repeat
if there is a submenu).
Press the Rotary Encoder to select the default setting to be changed. The selection takes on the reverse
video format (dark background, light text) when selected. Turn the Rotary Encoder to change the value
of the parameter. To accept the new setting, press the Rotary Encoder. To exit the menu without saving
the change, press the ESC key.
For a complete listing of the Program mode menu options, see the section titled
Navigation on pg.
are listed where applicable.
The default settings may also be changed by entering the Parameter Number of the setting to be
changed at the Direct Access menu (Program Direct Access applicable parameter number). A
listing of the Direct Access/Parameter Numbers and a description of the associated parameter may be
found in the section titled
Viewing Changed Parameters
A listing of all parameters that have been changed from the factory default setting may be viewed
sequentially by accessing the Changed From Default screen (Program Utilities Changed From
Default).
Note:
Parameter
The Changed From Default feature allows the user to view (or change) the parameters that are
different from the default or the post-reset settings. Once the Changed From Default screen is
displayed, the system automatically scrolls through all of the system parameters and halts once reaching
a changed parameter.
The Rotary Encoder may be clicked once clockwise to continue scrolling forward or clicked once
counterclockwise to begin scrolling in reverse. With each click of the Rotary Encoder from a stop, the
system scrolls through the parameters and stops at the next parameter that has been changed.
Pressing the Rotary Encoder while a changed parameter is displayed accesses the settings of the
parameter for viewing or changing.
Pressing ESC while the system is performing a Changed From Default search terminates the search.
Pressing ESC when done searching (or halted at a changed parameter) returns the system to the
Program Menu.
Figure 28. Changed From Default screen.
WX9 ASD Installation and Operation Manual
48. Menu items are listed and mapped for convenience. The Direct Access Numbers
Direct Access Parameter Information on pg.
F201
was changed to create the example shown below in
Program Menu
69.
Figure
28.
39
Advertisement
Table of Contents
