Page 7
Alarms Tab Introduction System Tab Calibrations Tab Units Tab Memory Tab...
Page 8
Introduction Water Depth Battery Voltage Water Temperature Speed Over Water* Fish Thermocline and Structure Bottom Shape and Type Transducer Frequency*...
Page 9
Installation Optional Package 50 kHz wide cone angle 200 kHz narrow cone angle dead zone fish not seen...
Page 10
Installation DO NOT NOTICE: DO NOT Apply marine sealant to all screw threads to prevent water from seeping into the transom. Transducer should extend 1/8" below fiberglass hull or 3/8" below aluminum hull Mount the transducer parallel with the bottom. Mount the transducer cable cover well above the waterline.
Page 12
Installation Adjust the speed sensor so it is parallel with the bottom of the boat. If the speed sensor is not adjusted properly, the sonar may experience inaccurate or degraded speed readings. Drill a 3/4” hole well above the water line. Coat the inside of the hole with Marine Sealant.
On the Water On the Water This fi sh is currently in a Dead Zone and is not detected by the sonar. The fi sh is in the coverage area of the transducer, but remember the fi rst strong return sets the bottom level.