Table of Contents
Advertisement
–
Turn thermostat knob (A) anticlockwise to position '0'=off (a slight resistance
will be felt just before this position).
–
Pull out mains plug.
7. D/C operation
Do not use any additional form of energy (mains/gas). A safety fuse must be
installed in the electricity supply between battery and refrigerator in a duct.
12 V: maximum 15 amps; 24 V: maximum 7.5 amps,
Cable cross section
2.5 mm 2
4.0mm 2
6.0 mm 2
It is not necessary to consider the polarity when connecting the unit. Check that
the battery voltage and line voltage data correspond to the type-plate on the back
of the unit.
If no batteries are used independently of the vehicle, the mobile cooler should not
be operational when the vehicle is in motion, since the battery can discharge to
the extent that the vehicle engine cannot restart when the vehicle is at a standstill.
During transport, the door safety button (G) must remain depressed, so that the
door is kept in a closed and safe position.
Recommendation: before journey, pre-cool the unit using A/C operation.
To turn on
The car plug must be mounted according to your car on the connecting cable into
the plug connector/cigarette lighter.
When using battery operation, the cooling performance is not thermostatically
regulated, i.e. knob (A) is ineffective.
When knob (A) is ineffective or if the temperature is unnecessarily too low:
Turn off unit
Pull out plug from socket.
8. Liquid gas operation
Do not use any additional form of energy (mains/battery). The unit must not be
connected to town or natural gas pipelines. It is only suitable for use with
propane/butane gas (e.g. Calor Gas, Camping Gaz, Caravangas, etc).
All manuals and user guides at all-guides.com
until
until
until
max. cable lengths
12V
24 V
2.5 m
5 m
4.0m
8 m
6.0m
12m
5
Advertisement
Table of Contents
