Table of Contents
Advertisement
All manuals and user guides at all-guides.com
1. INTRODUCTION
Thank you for expressing your confidence in our products by
purchasing the BEHRINGER ULTRABASS BB115. This cabinet
is built with the outstanding BUGERA
speaker cone is made of special high-quality paper that provides
rich bass tone and clear middle frequencies.
Bass players, who love the warm and direct sound of a classic
paper cone, will appreciate the high quality and workmanship as
well as the extremely high power output of this speaker. All these
characteristics make your ULTRABASS BB115 a high-value,
dependable companion on the stage, in the studio or in your
practice room.
1.1 Shipment
The
BB115
was carefully packed at the assembly plant to assure
secure transport. Should the condition of the cardboard box
suggest that damage may have taken place, please inspect the
unit immediately and look for physical indications of damage.
+
+
+
+
1.2 Initial operation
Connect the ULTRABASS BB115 to a power amplifier using
the speaker connectors located in the back.
+
1.3 Warranty
Please take a few minutes and send us the completed warranty
card within 14 days of the date of purchase. You may also register
online at www.behringer.com. The serial number needed for the
registration is located in the back of the unit. Failure to register
your product may void future warranty claims.
bass speaker. The
TM
2. CONTROL ELEMENTS AND CONNECTIONS
ULTRABASS BB115
2. CONTROL ELEMENTS AND
CONNECTIONS
Fig. 2.1.: Control elements and connections
You can connect a footswitch (e.g. MIDI FOOT
CONTROLLER FCB1010) to this 1/4" TS connector to
remotely enable/disable the tweeter. When the tweeter is
enabled, you get a harder, more direct sound (Hard Attack).
When the tweeter is disabled, the entire sound spectrum is
reproduced only on the bass speakers (Soft Attack).
The loudspeakers of the ULTRABASS series feature a
1/4" TS connector in the INPUT/LINK section as well as two
professional speaker connectors (compatible with
NEUTRIK
SPEAKON
). All connectors are wired in parallel,
®
®
which means that all three connections are identical in their
function. Therefore, you can connect a second speaker to
the
link connector output
amplifier. This way, you can utilize short cables and will
require no additional connectors on your amp.
+
+
This table shows the correct polarity of the connectors:
Plus pole (POS) = Tip (TIP) on the 1/4" TS connector or 1+
on the professional speaker connector.
Minus pole (NEG) = Sleeve (SLV) on the 1/4" TS connector
or 1- on the professional speaker connector.
+
SERIAL NUMBER. Please take a few minutes and send us
the completed warranty card within 14 days of the date of
purchase; failure to do so may void future warranty claims.
You may also register online at www.behringer.com.
without going directly to the
5
Advertisement
Table of Contents
