Sony KD-65X9500B Service Manual page 73

SAVE CHANGING DATA 1 (Only when B* board is replaced)
1) 1) In Digital service mode In "Digital" service mode
( "002 MODEL" category)
000 SEGSelect segment information
001 DEST Select destination information
002 MODELNAME Select Model Name l
003 SERIAL Can be set Only Once for the new board
005 VAR_TYPE Select variable information
a. Change data for each model.
b. Press "Mute"
c. After a while, red "
d. For the items SEG, DEST, MODELNAME and VAR_TYPE,
after changing each item, service save ( mute + 0 ) is after changing each item service save ("mute"+"0") is
required. For the item SERIAL, after inputting the serial
number, press key "12" or "Enter" to save the data.
– Please save the items according to the sequence "SEG ->
DEST -> MODELNAME ->VAR_TYPE"
– When Saving the item "SEG", sometimes instead of "Writing",
the word "Pending" will appear. In this case, skip "SEG",
saving "DEST", "MODELNAME" and "VAR_TYPE" is OK.
Note : Please refer "RB2G WW Service Update Procedure for
Panel, Board and Software" (manual P/N 9-888-155- ) in TISS for
details. details
KD-65/85X9500B
d l
, "0" on remote sequentially . Red " WRITE
WRITE " disappears. Green Done will be displayed for a while, which means writing process is done.
" is shown. This indicates writing is in process.
ADJUSTMENT
74