Garmin eTrex Summit Quick Start Manual

eTrex Summit Description
eTrex Summit Description
1
Internal
GPS Antenna
UP
Button
PAGE/COMPASS
DOWN
Button
Button
POWER
ENTER/MARK
Button
Button
LCD Display
Compass
(with backlight)
Sighting
Marks
External Power
and Waterproof Case
Data Connector
Barometric
Pressure
Battery
Sensor
Compartment
eTrex Summit Buttons
eTrex Summit Buttons
2
The PAGE Button:
• Switches display pages.
• Allows you to exit/quit a function.
• Press and hold the PAGE button to
turn the Electronic Compass on and
display the Pointer Page. When the
Electronic Compass is on, press and
hold the PAGE button to turn it off.
The POWER Button:
• Press and hold to turn the unit on/off.
• Press to turn the display backlight
on/off.
The UP/DOWN Buttons:
• Select options on pages and menus
• Adjust Contrast on SkyView Page
• Zoom in and out on Map Page
• Cycle through trip computer data
• Cycle through elevation computer data
The ENTER Button:
• Confirms data entry or menu selections
• Displays Options on main pages
• Press and hold the ENTER
button to activate the 'Mark Waypoint'
page
eTrex Summit Setup
Installing the Batteries
3
The eTrex Summit operates on two AA batteries (not included),
which are installed at the back of the unit. To install the batteries,
remove the battery cover by turning the D-ring at the back of the unit
1/4 turn counter-clockwise. Insert the batteries into position observ-
ing proper polarity. Attach the battery cover by turning the D-ring
1/4 turn clockwise.
Battery Cover
D-ring
Selecting a Page
4
All of the information needed to operate the eTrex Summit is
found on six main "pages" (or display screens). These pages are the
SkyView, Map, Pointer, Trip Computer, Elevaton, and Menu. Once
power is applied, press the PAGE button to switch between pages.
PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE
SkyView Map Pointer Trip Computer Elevation
eTrex Summit Setup
Finding Your Current Position
5
Before you can actually use your eTrex Summit for navigation,
you must first obtain a fix on your current position. To do this, take
your eTrex Summit outside and find a large, open area that has a
clear view of the sky. Press and hold the POWER button to turn
the unit on. You'll see the Welcome Page for a few seconds while
the eTrex Summit performs a self-test, followed by the Satellite
Page. The eTrex Summit needs to receive at least three strong
satellite signals to find your location.
When you see the "READY TO NAVIGATE" message on the
Satellite Page, eTrex Summit has found your location.
 NOTE: The first time you use your eTrex Summit, it could
take up to five minutes to find your location. After the
first time use, eTrex Summit only needs about 15 to 45
seconds to find your location. If the eTrex Summit does
not display your local time (bottom of the Menu Page),
follow the instructions in the Getting Started section of
your Owner's Manual to set the correct time.
Satellite
Welcome
Page
Page
Backlighting and Contrast
6
To turn the backlighting on, press and release the POWER
button from any screen. The backlight is timed to stay on for 30
PAGE PAGE seconds to save battery power. To adjust the screen contrast, press
the PAGE button until you see the SkyView Page. Press the UP
button to make the screen darker, press the DOWN button to
Menu
make the screen lighter.
"Ready To
Navigate"