Connecting A Wi-Fi Device Using A Password - Verizon CR1000A User Manual

• Alternatively, you can enter the router's PIN shown on this
screen into the WPS user interface of your device, if this
PIN mode is supported by your Wi-Fi device.
4. After pressing the WPS button on your router, you have two
minutes to press the WPS button on the client device before
the WPS session times out.
When the WPS button on your router is pressed, the Router
Status LED on the front of your router begins flashing blue.
The flashing continues until WPS pairing to the client device
completes successfully. At this time, the Router Status LED
turns solid white.
If WPS fails to establish a connection to a Wi-Fi client device
within two minutes, the Router Status LED on your router
flashes red for two minutes to indicate the WPS pairing
process was unsuccessful. After flashing red, the light
returns to solid white to indicate that Wi-Fi is on.
Note: Wi-Fi Protected Setup (WPS) cannot be used if WPA3
security is enabled or SSID broadcast is disabled or if MAC
address authentication is enabled with an empty white list.

CONNECTING a WI-FI DEVICE USING a PaSSWORD

1. Verify each device that you are connecting with Wi-Fi has
built-in Wi-Fi or an external Wi-Fi adapter.
2. Open the device's Wi-Fi settings application.
02 / CONNECTING YOUR
VERIZON ROUTER
©2021 Verizon. All Rights Reserved
38