Installation Instructions - Blaupunkt B910AU User Manual


Please do not make products near the fire, contact liquid and avoid the damage to the product that
may lead to electric shock, fire and other accidents;

Please do not install and use this product in the environment that does not meet the installation
conditions. Otherwise it may cause the damage to the machine or injury to user;

Please do not arbitrarily change the emission frequency, increase the transmission power (including
add RF power amplifier), add external antenna or use other transmit antennas;

Please do not make interference to legitimate radio communication services during the using of product.
Once the interference occurs, user should immediately stop using the product and the product should not be
used unless the interference is disappeared;
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:

(1) this device may not cause harmful interference,

(2) this device must accept any interference received, including interference that may cause undesired,
operation.

Installation Instructions


The vehicle must meet the voltage, current and power that required, please check the conditions
before installation;

The installation should be done while the battery of the vehicle is disconnected;

To ensure that the product has been fitted with a fuse;

The installation of the product should not affect the safety of the operation and function of the
vehicle;

The installation position should not block the driver's sight and should not be on the place that the
brake, steering wheel, seat belts, airbags and other vehicle safety equipment should be;

Please confirm the matching condition of the vehicle interface before install this product, use the
appropriate patch plug if the interface is not matched;

Please be familiar with the connection of the vehicle before installation, confirm the position of the
piping, electrical wiring, fuel tank and other vehicle system components. Do not touch or damage these
components and avoid the exposure of wires that may cause corrosion, leakage, etc.;

Please do not conduct the installation in place of condensation, drench water sites, high humidity,
containing dust and oil smoke. If water, moisture, dust and oil smoke enter the product, it may cause smoke,
fire or failure;

Please do not move or disassembled the existing screws, nuts, bolts, clips, connecting fixed
appliances, accessories and so on, do not change or remove vehicle incidental contact system and wire
clip, otherwise it may impair the function of automobile safety;

In order to avoid the occurrence of fire damage to the product or vehicle, please do not allow the
existing power supply circuit overload when power the product; Please be sure that the power wires
have insulation treatment and install with fuses, circuit breakers and relays;

Please use nonconductive tape in insulation treatment, wrap the ends of the wire and unused wire;
3