The Setting Method Of Jig (Portable) - Panasonic KX-TG9471B Service Manual

KX-TG9471B/KX-TG9472B/KX-TGA939T

11.5. The Setting Method of JIG (Portable)

This section explains the PC setting to use command required in Check Point (Portable) (P.44)
<Preparation>
• Serial JIG cable: PQZZ1CD300E*
• PC which runs in DOS mode.
• Batch file CD-ROM for setting: PNZZTG9471B
Note:
*: If you have the JIG Cable for TCD500 series
11.5.1. Connections
Connect the DC Power or Battery to BATT+ and BATT-.
Connect the JIG cable GND (black) to GND.
Connect the JIG cable UTX (yellow) to UTX and URX (red) to URX.
DC Power
1
or Battery
Note:
*: Comport names may vary depending on what your PC calls it.
URX
UTX
GND
J1
BATT+
Portable P. C. board
Note:
*: If you have the JIG Cable for TCD500 series
(PQZZ1CD505E), change
resistance. Then you can use it as a JIG Cable for both
TCD300 and TCD500 series. (It is an upper compatible JIG
Cable.)
Resistor Old value (kΩ)
R2 22
R3 22
R4 22
R7 4.7
UTX (yellow)
3
3 URX (red)
GND (black)
2
JIG Cable
J2
BATT-
60
the following values of
New value (kΩ)
3.3
3.3
4.7
10
To Serial Port
(com port 1*)
PC