GE GFWN1100L Owner's Manual & Installation Instructions page 22

Before you call for service...
Problem
Incomplete cycle or timer
not advancing
Loud or unusual noise;
vibration or shaking
No power/washer not
working or dead
Snags, holes, tears, rips
or excessive wear
Control time wrong
or changes
Not enough water
Washer pauses or has
to be restarted, or washer
door is locked and will
not open
Door unlocks or
press START and machine
doesn't operate
22
Possible Cause
Automatic load redistribution
Pump clogged
Drain hose is kinked or
improperly connected
Household drain may
be clogged
Drain hose siphoning; drain hose
pushed too far down the drain
Cabinet moving
All rubber leveling legs are not
rmly touching the oor
Unbalanced load
Pump clogged
Washer is unplugged
Water supply is turned off
Circuit breaker/fuse is
tripped/blown
Automatic self system checks
Overloaded
Pens, pencils, nails, screws or
other objects left in pockets
Pins, snaps, hooks, sharp
buttons, belt buckles, zippers
and sharp objects left in pockets
This is normal
This is normal
Pump clogged
This is normal
What To Do
11 or 15 rebalances may be done. This is normal operation.
sitting on it.
a plumber.
washer to check if it is level. If the washer is uneven, adjust
problem.
machine, run rinse and spin with no load. If normal,
unbalance was caused by load.
reset breaker. Washer should have separate outlet.
occur. It may take up to 20 seconds before you can use
your washer. This is normal operation.
See recommended maximum load sizes on page 11.
sometimes to reduce vibrations. When this happens,
the estimated time is increased causing time left to
increase or jump.
like top-load washers.
washers, and it takes 30 seconds to check the system.
The door will lock and unlock.
" to reduce forces
START.