Operating the wireless telephone switch
•
Call the telephone number to which the wireless switch is connected.
•
The telephone switch accepts the call after the preset number of dial tones and acknowledges this with a beep.
•
Enter your personal code via the keypad and confirm this with # . A „beep" confirms the entry.
•
Now select the switching function from the following list
Input
Function of the wireless outlets
1 *
A off
1 #
A on
2 *
B off
2 #
B on
3 *
C off
3 #
C on
* or 0 *
All off
# or 0 #
All on
Short overview operation (switch position „WORK")
Input
Explanation
Dial tel. no.
preset dial tones
2 2 0 5 1 9 7 1 #
Pers. code with 4 to 8 digits
1 *
Number of the switching function
Turn phone off
Operation is finished
Changing/deleting the channel assignment
You can change the channel assignment at any time as described in the chapter „Programming the wireless outlets".
You can also program several wireless outlets on one channel. To do so, perform the learning procedure with several wireless outlets at the same
time.
If you want to delete all channel assignments (for all wireless outlets and the telephone switch), press „RESET" (2) on the wireless remote control.
The function indicator blinks after deletion for control purposes (5). Press any key to turn the blinking off.
Individual deletion is not possible. Then you have to program the system.
Replacing the batteries
You must change the batteries if the function indicator no longer lights up when pushing the remote control buttons or when the transmission range
is significantly reduced. The wireless telephone switch signals a battery change acoustically during a remote switching process. Then 3 beeps sound
for acknowledgement.
Change the batteries as soon as possible to not loose the programmed settings. The battery change may not take longer than two
minutes.
Disposal of flat batteries
You, as the end user, are legally obliged (Battery Ordinance) to return all used batteries and accumulators. Disposal in the
household waste is prohibited! Batteries, including rechargeable batteries, which contain hazardous substances are marked by
symbols. These should not be disposed off in the household waste. The designations for heavy metals concerned are as follows:
Cd = cadmium, Hg = mercury, Pb = lead. You can return flat batteries and rechargeable batteries free of charge to collection points
in your local area, to our branches or anywhere else where batteries or rechargeable batteries are sold. You thus fulfill your
statutory obligations and make your contribution to the protection of the environment.
Environmental protection information
When no longer in use, this product may not be deposited in the normal household waste but should be brought to a collection point
for the recycling of electrical and electronic appliances. A symbol on the product, the operating instructions or the packaging draws
attention to this. The materials are recyclable as marked. By re-use, recycling or another form of using old appliances you are
making an important contribution towards the protection of the environment. Please ask your local authorities for the appropriate
disposal point.
Technical data
Operating voltage
Current consumption
Switching capacity
Dimensions (mm):
Radio frequency:
Range approx.
Technical specifications subject to change. We assume no liability for typographical errors. 03/2007
Phone: 09622 – 719910, Fax: 09622 – 7199120 www.IVT-Hirschau.de; Info@IVT-Hirschau.de
Wireless outlet
Wireless switch
230 V~ / 50 Hz
3600 W
150 x 70 x 80
100 x 70 x 35
433.92 MHz
50 m in free field, approx, 20 m in buildings
IVT Innovative Versorgungs-Technik GmbH, Dienhof 14, D-92242 Hirschau
Acoustic signal
A „beep" sounds
A „beep" sounds
A „beep" sounds
Remote control
9 V block battery
Stby < 8 µA
145 x 50 x 25