Startup And Shutdown; Startup Of This Device; Charger2; Detector - Konica Minolta AeroDR SYSTEM Operation Manual

3�1

Startup and shutdown

Normally, this device is used with the power on. When
not used for more than 1 day, operate the startup/shut-
down as follows.
HINT
• There is no specific sequence which should be started up
first, this device or the image processing controller.
• If the power synchronization function of the DR Detector
is enabled and the wired cable is connected, the startup /
shutdown of the DR Detector will be performed along with
the startup / shutdown of the synchronizing device.
• Refer to the "Operation Manual" of the image processing
controller regarding on/off for the image processing control-
ler
3�1�1

Startup of this device

AeroDR Detector, AeroDR 2 Detector
IMPORTANT
• Do not use a sharp object to operate the switch; doing so
may damage the AeroDR 2 1417HQ and AeroDR 2 1417S.
1
Prepare the DR Detector�
• If the DR Detector is inserted into the AeroDR
Battery Charger or AeroDR Battery Charger2
with a wireless connection, the DR Detector
should be removed.
• For a wired connection, confirm that the wired
cable is connected securely to the wired con-
nection connector of the DR Detector.
2
Press and hold the power switch for 2
seconds to turn it on, and confirm that the
LED (green) is slowly flashing or lit.
Power switch
LED (green)
AeroDR 3 Detector
1
Prepare the DR Detector�
• If the DR Detector is inserted into the AeroDR
Battery Charger2 with a wireless connection,
the DR Detector should be removed.
• For a wired connection, confirm that the wired
Cable is connected securely to the wired con-
nection connector of the DR Detector.
2
Press and hold the power switch for 2
seconds to turn it on, and confirm that the
Information LED (white) goes out gradu-
ally in the steps of lighting, flashing and
slowly flashing and then the Battery LED
(blue/orange) is on.
Information LED (white)
HINT
• The Battery LED changes according to the level of battery
power of the DR Detector.
AeroDR Interface Unit
1
Turn on the power switch, and confirm
that the LED (green) is on�
LED (green)
56
Power SW
Battery LED (blue/orange)
Power switch