Changing The Water Hardness Monitor; Changing Pre-Set Cup Sizes; 1-And 2-Cup Buttons; Special Cup Button; Cappuccino Button - Jura Capresso Impressa Z5 Operating Instructions Manual

Please note: If your water has a high calcium content (level 5 or 6)
and you use the Clearyl Filter Cartridge we recommend to decalcify
the Z5 once or twice a year (chapter 26.1).
24a. CHANGING THE WATER HARDNESS MONITOR
COFFEE READY
• Push the Rotary Dial until you hear a beep.
FILTER
• Turn the Rotary Dial until the display shows
HARDNESS 10º DH
• Push the Rotary Dial to enter the program.
• Turn the Rotary Dial until desired hardness level is displayed.
• Push the Rotary Dial to confirm the setting.
• Turn the Rotary Dial until the display shows EXIT.
• Push the Rotary Dial.
COFFEE READY
The Z5 will automatically remind you when it is time to decalcify
(chapter 29).

25. CHANGING PRE-SET CUP SIZES

Each beverage button has been set to certain values (pre-sets).
See chapter 5. You can change all pre-set values and enter ones.

25.1 1-AND 2-CUP BUTTONS; SPECIAL CUP BUTTON

This procedure is the same for all five coffee buttons (Fig. 3).
COFFEE READY
EXAMPLE: Changing the 1-cup Coffee Button. (Fig.3).
• Place a cup underneath the coffee spouts.
• Push and hold the 1-cup Coffee Button until the display
shows ENOUGH? PRESS BUTTON.
• When the coffee volume in your cup is at the new desired
level, push the 1-cup Coffee Button again. The display shows
CONFIRMED
COFFEE READY
From now on, this will be the amount of coffee the Z5 will produce
when you push this button.
Please note: the 1-cup and 2-cup buttons are independent of
each other. This means if you pre-set the 1-cup coffee button to
4 oz. the 2-cup button does not automatically produce 8 oz. You
can pre-set the 2-cup button completely independent.
Please note: when changing the volume for the special cup
button, place a cup under the auto cappuccino system.

25.2 CAPPUCCINO BUTTON

You can change the pre-set volumes for milk and coffee. This
allows you to adjust the volume exactly to your cup size.
Place a cup underneath the auto cappuccino system.
COFFEE READY
• Push and hold the Cappuccino Button until the display reads
ENOUGH MILK PRESS
• Once you have enough frothed milk in your cup, push the
Cappuccino Button again. Now the Z5 starts brewing the coffee
and the display shows
• Once enough coffee has been added to your cappuccino,
press the Cappuccino Button again. The display shows
CONFIRMED
COFFEE READY
Please note: You can also change the pre-set parameters for
the cappuccino button in programming (chapter 26.4)
22.
BUTTON.
ENOUGH? PRESS BUTTON.