Table of Contents
Advertisement
Please note: Cold milk will stay fresh up to 8 hours in the thermal
milk container. Do not leave the milk sitting outside the refrigerator
over night.
Please note: If there is not enough milk in the milk container, the
frother nozzle will dispense steam only. Stop the frothing action
and refill the milk container.
Please note: If the Dial points to the cappuccino position and
you do not get froth on your milk, check the following items:
a. Make sure all connections are tight.
b. Remove the venting tip (Fig. 5a) and squeeze the bottom part.
Milk might have closed the venting lip. Replace venting tip.
c. Skim milk will create considerably more froth than regular
milk. Soy milk will produce very little froth.
15. HOT MILK AND HOT CHOCOLATE
The Milk Button (Fig. 3) lets you produce hot milk or hot chocolate.
• Connect the long hose to the Dial system and insert the other
end into the container with cold milk or cold chocolate milk.
• Set the Dial to the cappuccino or the latte setting.
• Place a cup underneath the Auto Cappuccino System.
COFFEE READY
• Push the Milk Button
The display shows
MILK 20 SEC.
for 20 seconds and then stop automatically.
You can always change the duration by turning the Rotary Dial.
You can stop the milk flow by pushing the Rotary Dial or any
beverage button.
Tip: Without moving the cup you can now add coffee using the
Special Coffee Button. .
The Z5 will produce hot milk
16. SPECIAL COFFEE BUTTON
COFFEE READY
• Place a cup under the Auto Cappuccino System.
Make sure the long or the short nozzle system is installed.
• Push the SPECIAL COFFEE button (Fig. 3). The Z5 will brew a
cup coffee from the back nozzle and will stop automatically.
This button is useful if you want to create special milk drinks
that are not pre-set with any of the other buttons.
• As explained in chapter 11, you can change the strength and
the volume for this button, just before brewing.
17. CAPPUCCINO RINSING CYCLE
Ten minutes after using the milk or the cappuccino buttons, the
display will show the messages
READY,
CAPPU RINSE
Button will illuminate.
• Place a cup underneath the Auto Cappuccino System.
• Turn the Dial all the way down to the steam position (Fig. 5f).
• Push the rinse button.
seconds the Z5 will push hot water through the Dual Nozzle
System to remove any milk deposits.
COFFEE READY
• Turn the selector switch back to the Cappuccino or Latte position.
Please note: If the
CAPPU RINSE
do not plan to use the milk or cappuccino button within the next
few minutes, we highly recommend to run this rinse cycle without
delay. Warm milk inside the dual nozzle will deteriorate within a
short period of time and milk fats can create foul smells.
Please note: You can also perform a cappuccino rinsing cycle
manually using maintenance menu (chapter 26.1).
17.
CAPPU RINSE
CAPPU
RINSE,
COFFEE
and so on. At the same time the Rinse
CAPPUCCINO
RINSING. For a few
message appears and you
Advertisement
Table of Contents
