Ptz Receiver Configuration - GE KTD-400 User Manual

PTZ receiver configuration

Each PTZ receiver offers modes of operation choices, many of which can be programmed using a KTD-400
series keypad. It can also store preset position information if applicable.
To program a PTZ receiver, complete the steps in
component programming selection menu (Figure 21 on page 10), then do the following (for all cameras):
1. At the receiver site selection display
(Figure 22), use the numerical keys to enter
the receiver site to be programmed. The next
display will appear.
2. At the receiver setup display (Figure 23),
press 1 to begin receiver setup. The display
will automatically advance to the first setup
menu. (Pressing 2 allows you to set the
PTZ's presets. See
position programming
3. If you want the pan/tilt receiver to autopan,
enter one of the following choices in
Figure 24:
0 = Disables the autopan function.
1 = Assigns a 50% duty cycle when the
receiver is in autopan mode (unit
alternately pans and rests for 8 second
intervals).
2 = Assigns a 100% duty cycle when the
receiver is in autopan mode (unit
continuously pans).
3 = Causes the receiver to pan randomly
when in autopan mode.
The next display will appear.
4. You can program the receiver to resume
autopanning when power is restored after a
power loss. At the autopan autostart display
(Figure 25), press 1 to make the receiver
autopan when power is restored. Otherwise,
press 0. The next display will appear.
5. At the lens voltage display (Figure 26),
select the correct voltage for the receiver's
motorized lens. Press 0 for 6 volts, or 1 for
12 volts. The next display will appear.
System component configuration
PTZ receiver preset
on page 13.)
Figure 22. Receiver site selection display
ENTER RECEIVER SITE
NUMBER 00
Figure 23. Receiver setup display
1=SETUP 2=PRESETS
Figure 24. Pan cycle display
PAN CYCL? 0=0%
2=100% 3=RDM
Figure 25. Autopan autostart display
AUTOPAN AUTOSTART?
0=NO 1=YES
Figure 26. Lens voltage display
LENS VOLTAGE?
1=12v 0=6v
on page 10, press 2 at the
SEQ=NEXT
SEQ=NEXT
1=50%
SEQ=NEXT
SEQ=NEXT
SEQ=NEXT
11