System Component Configuration - GE KTD-400 User Manual

10 KTD-400 Controller Keypad
User Manual

System component configuration

After you have completed the KTD-400 keypad configuration, you can used the keypad to configure other
Digiplex system components. To configure these system components, begin at the normal operating display
and do the following:
1. In the normal operating display shown in
Figure 19, press and hold the Set key until
the display in Figure 20 appears.
2. In the menu in Figure 20, enter the access
code 9, 5, 1, Seq. The next display will
appear.
3. The component programming selection
menu (Figure 21) lets you select which
component (video switchers, PTZ receivers,
alarm interfaces, and CyberDomes) to
program.
To configure video switchers, alarm interfaces, and CyberDomes, press the appropriate number at the
component configuration selection menu (Figure 21) and refer to the programming instructions provided with
those products.
To configure PTZ receivers, press 2 at the component configuration selection display (Figure 21) and follow
the instructions in PTZ receiver configuration
Figure 19. Normal operating display
CAMERA 000
MONITOR 01
Figure 20. Code entry display
CAMERA 000
MONITOR 01
Figure 21. Component configuration selection display
1=SWTCH
4=CYBER
on page 11.
(CODE)
(----)
2=PTZ 3=ALRM
SEQ=EXIT