Electrolux LCB1AF10W0 User Manual page 16

16 www.electrolux.com
Problem
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the SUPER, or af‐
ter changing the tempera‐
ture.
The temperature in the ap‐
pliance is too low or too
high.
If your appliance is still not working properly after making the above checks, contact
the nearest Authorised Service Center.
Specify the model and serial number of your appliance when you contact Authorised
Service Center. This will accelerate the support received.
Possible cause
The lid is not closed prop‐
erly or the gasket is de‐
formed or dirty.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
The temperature regulator
is not set correctly.
The lid is not closed prop‐
erly.
The products' temperature
is too high.
Many products are stored
at the same time.
The thickness of the frost
on the inner liner is greater
than 4-5 mm.
The lid was opened too of‐
ten.
The SUPER function is
switched on.
Products to be frozen are
placed too closely to each
other.
The appliance is positioned
near the heat source.
Solution
Check if the lid closes
properly. Clean the gasket
or replace it in case of any
damage.
Refer to "Temperature reg‐
ulation" section.
The compressor starts af‐
ter a period of time.
Set a higher or lower tem‐
perature.
Check if the lid closes
properly and the gaskets
are not damaged or dirty.
Allow food to cool to room
temperature before stor‐
ing.
Store less products at the
same time.
Defrost the appliance. Re‐
fer to "Defrosting the freez‐
er" section.
Open the lid only if neces‐
sary.
Refer to "SUPER function"
section.
Make sure that there is
cold air circulation in the
appliance.
Refer to "Location" sec‐
tion.