Storage - Kohler N.A.M.P 6000 Operation Instruction Manual

TRANSPORTING&STORAGE
When the equipment is to remain idle for longer than 20 days, prepare the
Engine for storage as follows:
When the equipment is to remain idle for longer than 20 days, prepare the Engine for
storage as follows:
During extended storage periods the Engine must be started every 3 months and
allowed to run for 15 – 20 minutes or the Warranty is VOID.
1. CLEANING:
Wait for Engine to cool, and then clean Engine with dry cloth. NOTICE: Do not clean
using water. The water will gradually enter the Engine and cause rust damage. Apply a
thin coat of rust preventive oil to all metal parts.
2. FUEL:
To protect the fuel tank during storage, fill the tank with gasoline that has been treated
with a fuel stabilizer additive. Follow fuel stabilizer manufacturer's recommendations
for use.
Fill tank in a well-ventilated area away from ignition sources. If the engine is hot from
use, shut the engine off and wait for it to cool before adding fuel. Do not smoke.
3. LUBRICATION:
A. Change engine oil.
b. Clean out area around spark plug. Remove spark plug and pour one tablespoon of
engine oil into cylinder through spark plug hole.
C.Replace spark plug, but leave spark plug cap disconnected.
D.Pull Starter Handle to distribute oil in cylinder. Stop after one or two revolutions
when you feel the piston start the compression stroke (when you start to feel re-
sistance).
4. STORAGE AREA:
Cover and store in a dry, level, well-ventilated area out of reach of children. Storage
area should also be away from ignition sources, such as water heaters, clothes dryers,
and furnaces
5. AFTER STORAGE:
Before starting the Engine during or after storage, keep in mind that untreated gasoline
will deteriorate quickly. Drain the fuel tank and change to fresh fuel if untreated gaso-
line has been sitting for a month, if treated gasoline has been sitting beyond the fuel
stabilizer's recommended time period, or if the Engine does not start.
WARNING
13