To Handle The Indoor Unit - Daikin Altherma 3 R ECH2O Installer's Reference Manual

4 | About the box

4.3.3 To handle the indoor unit

Installer reference guide
26
a Handles (only required for transport)
b Thread cover
c Spillover connector
d Assembly wrench
e Shut-off valve
f Flat gasket
g O‑ring
h Securing clip
i Venting hose
j Drain pan hose
k Drain pan hose clamp
l Cable fixation for strain relief
m Cable tie
n O‑ring
o Chimney socket
p Securing clip
q Switch box metal insert
r Screw for switch box metal insert
s General safety precautions
t Addendum book for optional equipment
u Indoor unit installation manual
v Operation manual
Use the handles at the back and at the front to carry the unit.
NOTICE
The indoor unit is top-heavy as long as the storage tank is empty. Secure the unit
accordingly and only transport by using the handles.
If optional Backup Heater (EKECBU*) is installed, see the installation manual of the
Backup Heater.
a Screw plug
b Assembly wrench
c Handle
1 Open the screw plugs on the front and back of the tank.
2 Attach the handles horizontally and turn by 360°.
3 Use the handles to carry the unit.
4 After carrying the unit remove the handles, add the screw plugs again and
insert the thread covers on the plugs.
a
1
360°
c
2
ERLA11~16DAV3+W1 + EBSH/X(B)11+16P30+50DF
b
Daikin Altherma 3 R ECH₂O
4P663482-1A – 2021.11