Cutech 80100-CT Quick Start Manual

80100-CT UNIVERSAL STAND

Place upper brace, long, inside upper leg piece .
NOTE: Upper brace has two large, oval holes in each end , these holes should be on top when leg stand
is completely assembled.

Align holes on the upper brace with the holes on the leg piece. Insert two carriage bolts and hand
tighten using hex nuts.

Place lower leg piece inside upper leg brace. Place lower brace, long, on top of both leg pieces.

Align holes on all three pieces. Insert two carriage bolts and hand tighten using hex nuts.

Attach a second upper leg piece to the outside of upper race using two carriage bolts and hex nuts.

Next , attach lower leg piece to the inside of upper leg piece placing lower brace on top of both leg
pieces ( also on the inside of the leg stand ) . Insert two carriage bolts and hand tighten using hex
nuts.

Repeat the above steps once. This completes two of the four sides of the leg stand.

Place upper brace, short, inside upper leg piece.
NOTE: Upper brace, short, has two large, oval holes in each end; these holes should be on top when leg
stand is completely assembled.
ASSEMBLY
DESCRIPTION
Upper Brace, Long
Upper Brace, Short
Lower Brace, Long
Lower Brace, Short
Upper Leg
Lower Leg
Rubber Foot
Carriage Bolt, M8x1.25-16
Carriage Nut, M8x1.25
QTY
2
2
2
2
4
4
4
32
32