The Package Contains; Assembly And Adjustment - Stanley SM16 Instruction Manual

WARNING! To reduce the risk of injury, the
user must read the instruction manual before
use.
Wear safety glasses or goggles.
Wear ear protection.
Wear a dust mask.
Keep your hands away from this area.
V Volts
A Amperes
Hz Hertz
W Watts
min minutes
Alternating
Current
Date Code Position (Fig. 1)
The Date Code, which also includes the year of
manufacture, is printed into the housing.
Example:
Year of Manufacture

THE PACKAGE CONTAINS

1 Miter Saw
1 Blade wrench stored in wrench pocket
1 Saw blade
1 Dust bag
1 Vertical clamp
2 Work support
1 Rear support
1 Repeat cut plate
1 Instruction manual
♦ Check for damage to the tool, parts or accessories
which may have occurred during transport.
♦ Take the time to thoroughly read and understand this
manual prior to operation.
Description (Fig. 1,2,3,5,14,24)
WARNING: Never modify the power tool or any
part of it. Damage or personal injury could result.
a. Operating handle
b. Lower guard
c. Right side, fence
Direct Current
n No-Load Speed
0
Class II Construction
Earthing Terminal
Safety Alert Symbol
Revolutions or
/min.
Reciprocation per
(rpm)
minute
2019 XX XX
d. Table
e. Miter lock knob
f. Miter scale
g. Base
h. Holes for work support
i. Wrench
j. Bench mounting holes
k. Fence clamping knob
l. Trigger switch
m. Carrying handle
n. Dust spout
o. Lock down pin
p. Bevel clamp knob
q. Bevel scale
r. Hand indentation
s. Kerf plate
t. Miter detent
u. Date code
v. left side, fence
w. Brush cap
x. Spindle lock
y. Hole for padlock
z. Angle position stop
aa. Bevel position adjustment stop
bb. LED switch
cc. Vertical position adjustment stop
dd. Lock-off lever
ee. Repeat cut plate
ff. Dust bag
gg. Vertical clamp
ii. Work support
jj. Fence stop screw
ii. Work support
mm. Rear support

ASSEMBLY AND ADJUSTMENT

WARNING: To reduce the risk of injury, turn unit
off and disconnect machine from power source
before installing and removing accessories,
before adjusting or changing set-ups or when
making repairs. Be sure the trigger switch is in the OFF
position. An accidental start-up can cause injury.
Unpacking (Fig. 1, 2, 4, 5)
♦ Remove the saw from the packing material carefully
using the carrying handle (m).
♦ Use the supplied blade wrench(i) to mount the rear
support (mm) to the back of base(g).
♦ Mounting the miter lock knob(e) to the miter saw arm.
ENGLISH (
Original Instructions)
43