GE Profile JD968 Installation Instructions Manual page 11

Installation Instructions
Standard Installation Instructions
D
Remove the Protective
D4
Channels (if provided)
Carefully remove the protective
channels from the sides of the glass
cooktop. This may require a slight
lifting of the range to remove the
weight of the range from the protective
channels.
Glass Cooktop
Remove Protective Cover From
Both Sides After Range Is In Cabinet
Check For Proper Installation
D5
of the Stop Screw
Look at both sides of the range under
the door. The stop screws must be
located in the notch on the sides of the
range, and not touch the top of the
notch when the range is fully seated
on the countertop. If the screws do not
meet the requirements, move the
screws to a position that meets these
requirements. (See illustration below.)
Side
Trim
Shoulder
Screw
Protective Cover
Notch in Bottom
of Side Trim
Clear
Attach the Lower Trim
D6
Attach the lower trim (supplied
separately with the range) to the
bottom of the vertical side trim with
the 2 screws supplied.
Side
Trim
End Flange
& Tab On Lower
Trim Fits Inside
Side Trim Top Flange
1/2" Wide
Lower
Trim
11
cont.
Attach
1 Screw
Each Side
(Continued on following page)
Lower
Left
Corner
Front
Frame