GE JSS28DN Dimensions And Installation Information

JSS28DN
GE 30" Slide-In Electric Range
®
Dimensions and Installation Information
Optional Kits
KW Rating
(Available at additional cost)
240V 11.9
JXS32 - Backguard
JXS56 - Lower Trim Kit
208V
8.9
JXS86 - Vertical Side Trim Kit
JXS77 - Body Sides
Note: To reduce possiblity of scorching of the
side wall adjacent to the heating elements, it is
recommended a minimum of 6" spacing from
adjacent side walls be allowed for possible
extended, high-heat, no-load operation of
heating elements.
Receptacle Location: For all 30" Slide-In Ranges
locally approved flexible service cord or conduit must
be used because terminals are not accessible after
range installation. See shaded area in drawing for
location of electrical outlet box. Recommended outlet
locations allow range to be installed directly against
rear wall.
Note: Cabinets installed adjacent to slide-in ranges
must have an adhesion spec of at least 194.°
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
For answers to your Monogram, GE Profile
®
GE appliance questions, visit our website at
®
ge.com or call GE Answer Center
®
800.626.2000.
35-7/8"–38"
from floor to
with Standard Clean Oven
countertop
2-7/8"
To Front
Surface Of
Countertop
If you are NOT using the
optional Filler or Backguard:
or
™
service,
23-3/16
Electrical 13" Max.
Outlet Area
15" Min.
25
2-1/2
7-1/2
2-1/2
30
Accessory
Backguard
24
31-1/4
36-1/4
20-5/8" Door
Clearance
From Front
Surface of
Countertop
*JXS37 is 5-1/4" and JXS32 is 4"
25-3/4**
(excluding handle)
**Total depth from wall to
If you are using the optional
Filler or Backguard:
23-3/16
30
30 " Mi n.
Recommended
6" Min.
From Walls
A/B*
30 " Mi n.
23-3/16
35-7/8"–38"
from floor to
countertop
2-1/2
30
front of closed oven door
including handle is 27-13/16.
24
2-7/8"
To Front
Surface Of
Countertop
25
30 20-5/8" Door
Clearance
From Front
Dimension and installation information are shown in inches.
Surface of
Countertop
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Shave Raised Edge To Clear
31-1/8" Wide Control Panel
Excluding Models JSS28 and JSP39
9/16
Acceptable
Electrical
13" Max.
Outlet Area
15" Min.
25
7-1/2
2-1/2
Accessory
Backguard
A/B*
31-1/4
36-1/4
Listed by
Underwriters
Laboratories
*JXS37 is 5-1/4" and J
25-3/4**
(excluding handle)
**Total depth from wall
front of closed oven d
including handle is 27
Specification Revised 08/08
320639