Decals - MULTIQUIP DFG Series Manual

DECALS.

EYE AND EAR
PROTECTION
REQUIRED
3
5
STARTING INSTRUCTIONS
PROPANE CONVERTED UNITS ONLY
OPEN FUEL VALVE
DO NOT USE CHOKE
3.
DFG SERIES SURFACE GRINDERS
WARNING
SP8-5040
WARNING
KEEP
GUARDS IN
PLACE
SP8-5050
WARNING
4. 1 SEC
CLOSE FUEL VALVE. INSPECT
ALL FUEL HOSES AND FITTINGS
FOR LEAKS AND DAMAGE
5.
AFTER STOPPING ENGINE.
CONSULT OPERATOR'S MANUAL
FOR SPECIFIC INFORMATION.
7
OPERATION AND PARTS MANUAL REV #3 (07/13/06)
WARNING
1) BEFORE OPERATING THIS MACHINE, THOROUGHLY READ AND
COMPREHEND THE CONTENTS OF THE APPLICABLE OPERATOR'S MANUAL.
2) BEFORE STARTING THE POWER SOURCE, RAISE THE BLADE TO FULLY
TO CLEAR THE WORK SURFACE. VISUALLY INSPECT THE BLADE/ARBOR
SHAFT.
3) THIS MACHINE IS DESIGNED TO BE PULLED TOWARD THE OPERATOR
DURING NORMAL OPERATION.
IMPROPER STARTING/OPERATING PROCEDURES CAN RESULT IN PRORERTY
1
DAMAGE AND/OR PERSONAL INJURY.
BEFORE HOISTING THIS MACHINE
CONSULT THE APPLICABLE OPERATOR
4
MANUAL. IMPROPER HOISTING
PROCEDURES CAN RESULT IN
PROPERTY DAMAGE AND/OR PERSONAL INJURY.
7
KEEP CLEAR
OF ROTATING
PARTS
6
This machine can be operated from the following power sources:
115 VOLT, 20 AMPERE, 60 HZ, AC ELECTRIC
230 VOLT, 10 AMPERE, 60 HZ, AC ELECTRIC
UTILIZE 8-3 AWG MINIMUM, COPPER STRANDED EXTENSION CORDS.
Improper extension cords will cause the moto to over heat and deploy the internal thermo
protection device. the device is intended to stop the motor before the heat can cause
permanent damage. It must be manually activated to restart the motor after a sufficient
time for cooling is allowed.
OPERATE THE MOTOR FROM THE PROPER POWER SOURCE
A voltage selector switch is provided on the electric motor. Retain the switch in position
with a long shank type lock. Determine the voltage and amperage capacity of the power
source before operating the motor. Do not operate the motor on an improperly selected
power source. Do not deploy the voltage selector switch while the motor is operating.
Improper voltage and amperage capacity can result in motor damage and/or personal
injury.
SG24-5060
DECALS.
CS8-5030
2
WARNING
WARNING
SP8-5030
WARNING
OR
SP8-5070
8
PAGE 76