Placement Of Mounting Plate; Removing The Mounting Plate; Finding The Wall Studs - GE Profile Advantium SCA2001KSS Installation Instructions Manual

1
PLACEMENT OF THE MOUNTING PLATE
REMOVING THE OVEN FROM
A
THE CARTON/REMOVING THE
MOUNTING PLATE
Remove the box containing the installation
1
instructions, filters, exhaust adaptor and the
small hardware bag.
Stand the oven on its control panel side. Use a portion
2
of the carton or some other material to protect the
outer case from being damaged.
Control Panel Side
The mounting plate is attached to the back of the
3
oven. Remove the 2 screws holding it to the oven.
The plate will be used as the rear wall template and
for mounting the oven to the wall.
Set the oven upright. Remove and properly discard
4
plastic bags and Styrofoam. Remove any adhesive tape
(if there is any) on the exhaust adaptor, the grease
filters and the power supply cord.
Open the oven door and remove any accessories
5
from inside the oven.
Installation Instructions
Mounting
Plate

FINDING THE WALL STUDS

B
Wall
Studs
Center
Find the studs, using one of the following methods:
1
A. Stud finder—a magnetic device which locates nails.
B. Use a hammer to tap lightly across the mounting
surface to find a solid sound. This will indicate a
stud location.
After locating the stud(s), find the center by probing
2
the wall with a small nail to find the edges of the stud.
Then place a mark halfway between the edges. The
center of any adjacent studs should be 16" or 24" from
this mark.
Draw a line down the center of the studs.
3
THE OVEN MUST BE CONNECTED TO AT LEAST
ONE WALL STUD.
8
OR