Canon Creative Park Clowns on Stilts Line Dance Assembly Instructions Manual

(Moving) Clowns on stilts line dance : Assembly Instructions
h t t p : / / w w w. c a n o n . c o m / c - p a r k / e n /
View of completed model
Assembly Instructions : Eleven A4 sheets (No. 1 to No. 11)
* Build the model by carefully reading the Assembly Instructions , in the parts sheet page order.
*Hint: Trace along the folds with a ruler
and an exhausted pen (no ink) to get a sharper, easier fold.
Assembly Instructions
Mountain fold(dotted line)
Make a mountain fold.
Valley fold(dashed and dotted line)
Make a valley fold.
Scissors line(solid line)
Cut along the line.
Cut in line(solid line)
Cut along the line.
Scissors, set square, glue(We recommend stick glue), pencil, used
Tools and materials
ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley
Assembly tip
fold lines and make sure rounded sections are nice and stiff.
Glue, scissors and other tools may be dangerous to young children
Caution
so be sure to keep them out of the reach of young children.
*When you pull on the lever at right,
the long-legged clowns begin to dance,
with all three clowns lifting their long
legs and the puppy ducking its head.
Glue
The glue spot(colored dot)
shows where to apply the glue.
Glue spot(Red dot)
Glue parts with the same number together.
Glue spot(Green dot)
Glue within the same part.
Glue spot(Blue dot)
Glue to the rear of the other part.
©
Canon Inc.
Before starting assembly : Writing the number of each section on its back side
before cutting out the sections is highly recommended.
(* This way, you can be sure which section is which even after cutting out
the sections.)
Round bar : Use to give parts a curved surface.
Tweezers : Useful in working with fine parts.
Caution: This circus clown dance model uses three pieces of thread.
Please use strong thread such as silk thread (three pieces 30 cm each in length).
Turn the parts upside down and glue them
in place as shown in the illustration.
Caution: Do not assemble the parts into a box shape yet at this stage.
©
Hideharu Naitoh & unity design
Indicates where sections should
be glued together.
Indicates where to insert sections.
Do not glue the sections together.
Cut along the line.
Use care here.