Table of Contents
Advertisement
Install the Card
I I n n s s t t a a l l l l t t h h e e C C a a r r d d
NOTE
To install the PXGX UPS card:
1.
Verify that all six DIP switches on the card are in the OFF position (see
Figure 1. Verify DIP Switches are OFF
2.
If not already done, record the MAC address for future reference (see the
3.
Remove the X-slot
NOTE
4.
To prevent electrostatic discharge (ESD), place one hand on a metal surface, such as the UPS panel.
5.
Slide the card into the open slot and secure with the screws removed in
Figure 2. Secure the PXGX UPS Card
6.
From your laptop, go to www.eaton.com/pxgx.
2
Eaton Power Xpert® Gateway PXGX UPS Card Quick Start Instructions 164950240—Rev 04
The hot-swappable PXGX UPS card can be installed without turning off the UPS or
disconnecting the load.
6 5 4 3 2 1
OFF
ON
®
cover from the UPS. Retain the screws.
If another card is already installed with an attached communication cable, disconnect the
cable and then remove the card.
Figure
1).
Installation Checklist
section).
Step 3
(see
Figure
2).
Advertisement
Table of Contents
