National Cycle N941 Installation And Owner's Manual

PARTS LIST
Description
Lightbar Assembly, N941 or N941E
Connectors, Scotchlok
PREPARATION
1. Make certain the motorcycle is securely positioned for this
installation. Cover the front fender with a protective cloth to avoid
scratches.
2. Remove the headlight and rim assembly from the headlight
shell (phillips screwdriver).
3. Remove the cover from the front of the turnsignal mount (hex
key wrench, 3mm). Cover will not be re-used.
4. Remove the nuts holding the headlight bracket to the lower
triple-clamp (socket, 12mm). Make sure the headlight shell stays
in place.
INSTALLATION
1. Remove the screws holding the headlight bracket to the lower
triple-clamp.
2. Slide the Lightbar center bracket between the headlight brack-
et and the lower triple-clamp. Reinstall the headlight bracket
screws to through the headlight bracket, the Lightbar center
bracket and the lower triple-clamp. Loosely install the nuts.
3. Adjust the Lightbar position to be symetrical on the motorcycle
and tighten the nuts to 13 ft/lbs (19Nm).
4. Route the wires from the center of the Lightbar up through the
Lightbar bracket, around the headlight bracket, then into the
headlight shell.
5. Using the Scotchlok Connectors, connect the wires as follows
(pliers):
Wire color of N941 light bar
Red, long (Passing Lamps) to
NOTE: Grounding is through the front fork.
6. Check the operation of the light on the Lightbar, correct the
connections as needed.
7. Reinstall the headlight and ring assembly. Check the lights
again for proper operation.
NOTE: Check local regulations for proper passing lamp
operation. Some states require passing lamps be lit only
with hi-beam.
Qty.
1
6
Wire colors of VL800
headlight hi-beam (White)
Ground is Black/white
Lo-beam is Yellow.
INSTALLATION AND OWNER'S MANUAL
N941 or N941E (European) LIGHT BAR for
Suzuki® VL800 Volusia
NOTE: right and left on the motorcycle are determined from
the rider's position.
Position light bar
assembly between
the lower triple
clamp and the head
light shell mounting
bracket.
Note, Light Bar Wiring Helpful Hints:
The long RED wire is the main power wire for the spotlights on
the light bar. Connect that to the main power source from the
headlight. Either the High Beam wire or the Low Beam wire.
The choice is your preference. Turn on bike and Check.
The Light Bar attached to the front fork of the motorcycle serves
as the ground in most cases. A precautionary step to insure
proper grounding is to take one of the Ground wires from the
existing turn signals and ground that between the Light Bar
Mount and the Triple Tree Bracket.
Always start by doing one side at a time. Preferably the right
side or high side of the bike first.
Through Wire
Page 1 of 2
Wrench, 12mm
Socket, 12mm
Ratchet Wrench
Short Extension
#2 Phillips Screwdriver
Hex Key Wrench, 3mm
Slip Joint Pliers
Wire From Light Bar
Insert To Stop.
10-110741-000 10/01