Table of Contents
Advertisement
24
Rieju chassis
BRAKE OIL
Control
When the oil level is going to be checked, turn
the handlebar to verify that the upper part of
the main cylinder is levelled out.
Check the oil level is above the mark of the
minimum level in the tray of the rear brake.
And control there is enough oil for the front
brake observing by the peephole placed in the
pump.
Change
For the front brake, remove the cover (A/F
-17) after taking the screws out (B/F -17).
For the back brake, remove the cap (C/F -
18).
The quality of the used liquid should comply
with the specified regulations; since otherwise
the rubber gaskets can wear, causing leaks and
reducing the effectiveness of the brake.
Recommended brake liquid: DOT 4
ATTENTION: Brake liquid is abrasive.
ADJUSTMENT OF THE MINIMAL INTERVAL OF TURN
Start the engine and warm it up for some mi-
nutes in the 1000 to 2000 rpm interval spee-
ding up till the 4000 to 5000 rpm. When the
engine responds quickly to the acceleration,
that means it is hot.
Adjust the minimal zone of the engine turning
the screw for gas adjustment (A/F -19). Screw
to the right to speed up and to the left to slow
down.
Control the ideal interval of the engine with
an electronic tachometer connected to the
spark plug cable.
Chassis
B
A
MIN
C
MIX
MAX
A
F-17
F-18
F-19
Advertisement
Table of Contents
