GE Zoneline AZ28E09DAB Owner's Manual And Installation Instructions page 15

265 VOLT ELECTRICAL CONNECTION OPTIONS
WARNING:
Connection of this 265 V AC product to a branch circuit
MUST be done by direct connection in accordance with
the National Electrical Code. Plugging this unit into a
building mounted exposed receptacle is not permitted
by code.
These models must be installed using the appropriate
GE power supply kit for the branch circuit amperage
and the electrical resistance heater wattage desired.
Use the POWER CONNECTION CHART on page 17
to determine the correct kit required. One of the
following installation methods (A or B) must be used.
A. FOR SUBBASE INSTALLATION
Electrical subbase kits are available to provide a flexible
enclosure for direct connection.
Branch Circuit and
Unit Amperage Rating
15
20
30
The instructions provided with the selected subbase kit
must be carefully followed. It is the responsibility of the
installer to ensure the connection of components is
done in accordance with these instructions and all
electrical codes.
Installation Instructions
Proper GE Power
Subbase Kit Supply Kit
RAK204E15 RAK5172
RAK204E20 RAK5202
RAK204E30 RAK5302
B. FOR DIRECT CONNECT
INSTALLATION
If an electrical subbase is not used, direct connection to
branch circuit wiring inside the provided junction box
must be done in accordance with the following steps.
Order the following Kit for 265 volt direct connection as
required:
Branch Circuit and
Unit Amperage Rating
15
20
30
Proceed to the "MAKE ELECTRICAL CONNECTION
TO THE UNIT" section.
15
Power
Supply Kit
RAK5157
RAK5207
RAK5307