Commissioning - B+S Verro Series Installation And User Instructions Manual

Standard connec on point dimensions
VUFWW1-A63 655mm
VUFWW1-D3 655mm
VUFWWSP1-A63 475mm
VUFWWSP1-D3 475mm
UFWWK 588mm
UFWWSPK 407mm
UFWWD 588mm
UFWWSPD 407mm
Commissioning of appliance;
Before commencing an installation, all of the following shall be established;
(a) - The required gas type is available.
(b) - That the gas supply is adequate to satisfy likely simultaneous demands or peak loading.
(c) - That the capacity of the gas measurement system, meter or cylinder supply is sufficient to meet the
anticipated maximum demand.
(d) - The pressure of the gas available at the inlet to the consumer piping.
(e) - The maximum pressure supplied from the outlet of the gas measurement system, meter or cylinder in
the event of failure of the supply regulator or control.
(f) - Location of gas measurement system or meter.
Commissioning of this appliance (within Australia) shall be completed by a suitably authorised person who;
(a) - Installed the appliance when gas is available at the time of installation; or
(b) - makes gas available to the appliance if gas was not available at the time of installation.
The commissioning of an appliance shall take full account of special design features, information contained
in these instructions, and relevant appliance safety requirements.
7
B2
A2
C2
A1 A2 A3
150mm 692mm
150mm 692mm
150mm 692mm
150mm 692mm
96mm 777mm
100mm 777mm
96mm 777mm
100mm 777mm
A3
B1 B2
577mm 80mm 78mm
577mm 80mm 78mm
397mm 80mm 78mm
397mm 80mm 78mm
399mm 378mm 47mm
300mm 430mm 50mm
399mm 378mm 47mm
300mm 430mm 50mm
© B&S Commercial Kitchen Appliances Pty Ltd 2016
C3
B3
B3 C1 C2
465mm 525mm
468mm 524mm
385mm 525mm
386mm 524mm
480mm 503mm
300mm 530mm
480mm 503mm
300mm 530mm
C3
60mm
67mm
60mm
67mm
93mm
93mm
93mm
93mm