Advertisement
English
Our products are engineered to meet the highest standards of
quality, functionality and design.
We hope you thoroughly enjoy your new Braun appliance.
Before use
Please read the use instructions carefully and completely
before using the appliance.
Caution
•
The blades are very sharp! To avoid
injuries, please handle blades with
utmost care.
• Care shall be taken when handling the sharp
cutting blades, emptying the bowl and during
cleaning.
• This appliance can be used by persons with
reduced physical, sensory or mental capabili-
ties or lack of experience and knowledge if
they have been given supervision or instruction
concerning use of the appliance in a safe way
and if they understand the hazards involved.
• Children shall not play with the appliance.
• This appliance shall not be used by children.
• Always switch off and unplug the appliance
when it is left unattended and before assem-
bling, disassembling, cleaning and storing.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
• Before plugging into a socket, check whether
your voltage corresponds with the voltage
printed on the bottom of the appliance.
• This appliance is designed for household use
only and for processing normal household
quantities.
• Do not use the appliance for any purpose
other than the intended use described in the
user manual. Any misuse may cause potential
injury.
• Do not use any part in the microwave.
• Please clean all parts before first use or as
required, following the instructions in the Care
and Cleaning section.
Parts and Accessories
1
Safety button
2
Pilot light
3
Smartspeed switch / variable speeds
4
Motor part
5
EasyClick release buttons
6
Blender shaft
7
Beaker
8
Whisk accessory
a Gear box
b Whisk
6
9
350 ml chopper accessory «hc»
a Lid
b Chopping blade
c Chopper bowl
d Anti-slip rubber ring
10 1250 ml chopper accessory «bc»
a Lid (with gear)
b Chopping blade
c Ice blade
d Chopper bowl
e Anti-slip rubber ring
Unpacking
Take the unit out of the carton. Remove all pieces of
the packing. Remove any possibly extant labels on
the unit (do not remove the rating plate).
Pilot light
The pilot light (2) shows the status of the appliance, when it is
connected to an electrical outlet.
Pilot light
Appliance/operating status
Flashing red
Appliance is ready for use
Solid green
Appliance is released (switch release button is
pressed) and can be switched on.
Solid Red
Early warning about overheating.
Motor slows down, step by step,
till shut off. Let the appliance cool down.
It is ready for use again when the
pilot light flashes red.
If the maximum speed decreases under high load and long
running time you can still finish your preparation, however you
should let the appliance cool down afterwards.
How to Use the Appliance
Smartspeed switch for Variable Speeds
One squeeze, all speeds. The more you press, the higher the
speed. The higher the speed, the faster and finer the blending
and chopping results.
One handed operation: the Smartspeed switch (3) allows you
to turn on the appliance and control the speed with one hand.
Operating your Hand Blender
First use: Remove the transportation lock from the motor part
(4) by pulling it at the red strap.
Switching On (A)
The appliance comes equipped with a safety button for
releasing the Smartspeed switch. To safely turn it on, follow
these points:
• Press the safety button (1) with your thumb. The Pilot Light
will turn solid green.
• Immediately press the Smartspeed switch and adjust to the
desired speed.
NOTE: If the Smartspeed switch is not pressed within 2
seconds, the appliance cannot be switched on for safety
reasons. The pilot light will flash red. To switch the
appliance on, start again with first step.
• During operation you do not need to keep the safety button
pressed.
Advertisement
