Press the On Line key to place the printer on line. You'll see "Ready" in the control
panel window.
For more details about control panel menus, see the Control Panel section of this CD-
ROM.
Configuring EtherTalk software on your computer
You now need to configure your computer to send print data over the EtherTalk network.
Configuring your Macintosh for Ethernet communication
1. Select Control Panels from the Apple ( ) menu.
The Control Panels folder appears.
2. Double-click the Network control panel.
3. Click EtherTalk.
Depending on the type of EtherTalk hardware installed in your Macintosh, the correct
EtherTalk (Phase 2) icon will look like one of the following:
Note: You must select the EtherTalk Phase 2 icon (two arrows pointing in each direc-
tion or two arrowheads connected by a dotted line) as opposed to EtherTalk Phase 1
(one arrow pointing in each direction).
4. Close the network control panel.
Configuring EtherTalk software on a PC-compatible
Please refer to your computer's EtherTalk network card and Windows documentation for
configuration instructions.
Network activity LED
There is a light-emitting-diode (LED) inset into the face plate of the printer's rear bezel.
This flashes when there is activity between the printer and the network.
58