Pair Up With The Subwoofer; Wireless Network Setup - Philips 8000 Series User Manual

1
Connect the mains cable to the AC~
Socket of the unit and then into a mains
socket
2
Connect the mains cable to the AC~
Socket of the subwoofer and then into a
mains socket.
* Power cord quantity and plug type vary by
regions.

Pair up with the subwoofer

Automatic Pairing
Plug the Soundbar and the subwoofer into the
mains sockets and then press on the unit or
remote control to switch the unit to ON mode.
The subwoofer and Soundbar will automatically
pair.
» Determine the status based on the
wireless subwoofer indicator.
LED State
Fast blink
Constant on
Slow blink
Tips
•
Do not press Pair on the rear of the subwoofer, except
for manual pairing.
Manual Pairing
If no audio from the wireless subwoofer can be
heard, manually pair up the subwoofer.
12
Status
Subwoofer in pairing mode
Connected / Pairing successful
Connection / Pairing Failed
1
Unplug both units from the mains sockets
again, then plug them in again after 3 minutes.
2
Press and hold the Pair button on the rear
of the subwoofer for a few seconds.
» The Pair indicator on the subwoofer
will rapidly blink.
3
Then press
control to switch the unit ON.
» The Pair indicator on the subwoofer
will become solid when successful.
4
If the Pair indicator still keeps blinking,
repeat step 1-3.
Tips
•
The subwoofer should be within 6 m of the Soundbar
in an open area (the closer the better).
•
Remove any objects between the subwoofer and the
Soundbar.
•
If the wireless connection fails again, check if there is a
conflict or strong interference (e. g. interference from
an electronic device) around the location. Remove
these conflicts or strong interferences and repeat the
above procedures.
•
If the main unit is not connected with the subwoofer
and it is in ON mode, the unit's STANDBY indicator
will flash.
on the unit or remote