Bosch SHE3AR Series Operating Instructions Manual page 27

Delay start
You can delay the start of the cycle in
one hour increments up to 24 hours.
œ:‹‚ 1 hour delay
œ:ƒ... 24 hours delay
To set Delay start:
Press On/Off button (. Select a
1.
cycle.
Press Delay button ` until the
2.
displayed time corresponds with
your requirements.
Press Start button h to activate
3.
Delay start.
To cancel Delay start:
Press Delay button ` until œ:‹‹
1.
is indicated on the digital
display H.
Press Start button h to save
2.
setting.
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button h again.
Wash cycle end
The wash cycle has ended when the
display H reads ‹:‹‹.
Auto power off
This setting determines the length of
time the control panel stays
illuminated after the cycle is
complete. To save energy the
recommended setting is ˜:‹‚.
This setting can be adjusted from
˜:‹‹ to ˜:‹ƒ.
˜:‹‹ dishwasher does not turn off
automatically
˜:‹‚ dishwasher turns off
automatically after 1 minute
Operating the Dishwasher en-us
˜:‹ƒ dishwasher turns off
automatically after
120 minutes (2 hours)
To change the setting:
Press the On/Off button (.
1.
Hold down the selection button
2.
> X and press the Start button
h until the display H
indicates š:‹x (x can be any
number).
Release both buttons.
3.
Press the selection button >
4.
Xuntil the display H indicates
˜:‹x.
Press the selection button < 8
5.
until the display corresponds with
your requirements.
Press the Start button h.
6.
Switching off the appliance
Short time after the end of the wash
cycle:
Press On/Off button (.
1.
Remove the dishes when they
2.
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
27