Camshaft Drive - Detroit Diesel 4000 Series Service Manual

C 052.05.12 – AFTER-INSTALLATION OPERATIONS
Listed in Table 44 are the After-Installation Operations for the camshaft drive.
Level of Maintenance
1, 2 ,3 Install pushrods
1, 2 ,3 Install valve gear
1, 2 ,3 Install rocker covers
Install oil heat exchanger with coolant distribution
1, 2 ,3
housing and thermostat
1, 2 ,3 Install turbocharger
1, 2 ,3 Install oil supply line for turbochargers
1, 2 ,3 Install oil return lines for turbochargers
1, 2 ,3 Install coolant lines
1, 2 ,3 Install charge air coolant vent lines
1, 2 ,3 Install engine coolant vent lines
1, 2 ,3 Install charge air coolant lines (low temperature)
Install intake air system from turbocharger
1, 2 ,3
to charge air cooler
1, 2 ,3 Install Y-pipe at exhaust outlet housing
1, 2 ,3 Install vibration damper (if removed)
1, 2 ,3 Install engine carrier, gear case end
1, 2 ,3 Install fan drive
1, 2 ,3 Fill charge air coolant system
1, 2 ,3 Fill engine coolant system
1, 2 ,3 Enable engine power
1 = The engine is to be completely disassembled.
2 = The engine is to be removed but not completely disassembled.
3 = The engine is to remain installed.
Table 44 After-Installation Operations
All information subject to change without notice.
Copyright © DETROIT DIESEL CORPORATION
SERIES 4000 12/16V SERVICE MANUAL
Operation Reference
Refer to section C 055.05.11
Refer to section C 055.05.11
Refer to section C 056.05.11
Refer to section C 185.05.11
Refer to section C 101.05.11
Refer to section C 187.05.11
Refer to section C 188.05.11
Refer to section C 203.05.11
Refer to section C 205.05.11
Refer to section C 205.05.11
Refer to section C 207.05.11
Refer to sectionC 125.05.11
Refer to section C 141.05.11
Refer to section C 035.05.11
Refer to section C 231.05.11
Refer to section C 221.05.11
Operator Guide
Operator Guide
Refer to Operators Guide
C -573